Linux RAID Storage
[Prev Page][Next Page]
- Re: Setting up md-raid5: observations, errors, questions, (continued)
[Fwd: Strange RAID-5 rebuild problem], Bill Davidsen
Strange RAID-5 rebuild problem,
Michael Guntsche
Re: Severe slowdown with LVM on RAID, alignment problem?,
Michael Guntsche
Severe slowdown with LVM on RAID, alignment problem?, Michael Guntsche
Corrupted RAID 50 (aparently) array. Help needed., Nicolas Mella
Corrupted RAID 50 (aparently?) array. Help needed.,
Nicolas Mella
2x6 or 3x4 raid10 arrays ?,
Franck Routier
Understanding bonnie++ results,
Franck Routier
Re: Understanding bonnie++ results, Bill Davidsen
how to use mkfs.ext3 "stride=" on LVM on RAID correctly?,
Tomasz Chmielewski
[PATCH] The md RAID10 resync thread could cause a md RAID10 array deadlock,
K.Tanaka
Re: very poor ext3 write performance on big filesystems?,
Andreas Dilger
Is 'fd' partition type of any use ?,
Franck Routier
Article aimed at general audience,
Bruce Miller
md3: unsupported reshape (reduce disks) required - aborting,
Bernd Schubert
Kernel panic on RAID1 root after upgrade, Richard Ray
board/controller recommendations?,
Dexter Filmore
mismatch_cnt != 0,
Justin Piszcz
Odd performance observation for RAID0, Joe Landman
Increased Reliability by using Raid, Pete/Piet Delaney
Further clarification of the sync_action check behavior.,
Harrell, Thomas
MD sysfs/kobject issues in SAN environment., greg
RAID10 far (f2) read throughput on random and sequential / read-ahead,
Nat Makarevitch
How many drives are bad?,
Norman Elton
HDD errors in dmesg, but don't know why...,
Steve Fairbairn
suns raid-z / zfs,
Keld Jørn Simonsen
Create Raid6 with 1 missing member fails,
Sevrin Robstad
RAID5 to RAID6 reshape?,
Beolach
[BUG] OOPS 2.6.24.2 raid5 write with ioatdma,
Laurent CORBES
[BUGREPORT] The kernel thread for md RAID10 could cause a md RAID10 array deadlock,
K.Tanaka
Got raid10 assembled wrong - how to fix?,
George Spelvin
patch for raid10,f>1 to operate like raid0, Keld Jørn Simonsen
transferring RAID-1 drives via sneakernet,
Jeff Breidenbach
my io testing scripts, Keld Jørn Simonsen
howto on performance, Keld Jørn Simonsen
kernel BUG at drivers/md/md.c:5145!, Janos Haar
RAID5 how chage chunck size from 64 to 128, 256 ? is it possible ?,
Andreas-Sokov
ICH10 support, Mike Myers
mdadm 2.6 creates slow RAID 5 while mdadm 2.5.6 rocks,
Hubert Verstraete
Any inexpensive hardware recommendations for PCI interface cards?,
Steve Fairbairn
howto and faq,
Keld Jørn Simonsen
raid5: two writing algorithms,
Keld Jørn Simonsen
[PATCH] Dynamic RAID Stripe Cache Size, Yuri Tikhonov
Disk failure during grow, what is the current state.,
Steve Fairbairn
recommendations for stripe/chunk size,
Keld Jørn Simonsen
Deleting mdadm RAID arrays,
Marcin Krol
using update-initramfs: how to get new mdadm.conf into the /boot? Or is it XFS?,
Moshe Yudkowsky
raid1 or raid10 for /boot,
Keld Jørn Simonsen
mdadm 2.6.4 : How i can check out current status of reshaping ?,
Andreas-Sokov
raid10 on three discs - few questions.,
Janek Kozicki
RAID needs more to survive a power hit, different /boot layout for example (was Re: draft howto on making raids for surviving a disk crash),
Moshe Yudkowsky
non-fresh: what?,
Dexter Filmore
raid1 and raid 10 always writes all data to all disks?,
Keld Jørn Simonsen
Assemble Same RAID0 More than Once?, AndrewL733
draft howto on making raids for surviving a disk crash,
Keld Jørn Simonsen
/dev/sdb has different metadata to chosen array /dev/md1 0.91 0.90.,
Andreas-Sokov
mdadm: /dev/md1: Cannot reshape array without increasing size (yet)., Andreas-Sokov
Linux md and iscsi problems,
aristizb
raid problem: after every reboot /dev/sdb1 is removed?,
Berni
problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help ?,
Andreas-Sokov
- Re: problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help ?, Neil Brown
- Re[2]: problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help ?, Andreas-Sokov
- Re[2]: problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help ?, Andreas-Sokov
Documentation? failure to update-initramfs causes Infinite md loop on boot,
Moshe Yudkowsky
RAID 1 and grub,
Richard Scobie
which raid level gives maximum overall speed? (raid-10,f2 vs. raid-0),
Janek Kozicki
Re: which raid level gives maximum overall speed? (raid-10,f2 vs. raid-0), Bill Davidsen
Help, big error, dd first GB of a raid:-/,
Lars Schimmer
Check mdadm-Raid 5,
Michael Mott
linux raid faq,
Keld Jørn Simonsen
How many disks per SATA-II bus?,
Bruce Miller
In this partition scheme, grub does not find md information?,
Moshe Yudkowsky
problem with spare, acive device, clean degrated, reshaip RADI5, anybody can help,
Andreas-Sokov
[PATCH] Use new sb type,
Jan Engelhardt
Unable to eradicate previous version of device information, even with zero-superblock and dd,
Moshe Yudkowsky
BUG: possible array corruption when adding a component to a degraded raid5 (possibly other levels too),
Peter Rabbitson
striping of a 4 drive raid10,
Keld Jørn Simonsen
Message not available
write-intent bitmaps,
Russell Coker
safe mode for grow?, Nagilum
raid1, questions and/or ideas for improvement, Markus Hochholdinger
question about mdadm,
Edward Hourigan
hdparm patch with min/max transfer rate, and min/avg/max access times, Keld Jørn Simonsen
Error mounting a reiserfs on renamed raid1,
Clemens Koller
[PATCH reposted] raid1 load balancing, Samuel Tardieu
performance of raid10,f2 on 4 disks, Keld Jørn Simonsen
Fwd: Error on /dev/sda, but takes down RAID-1,
Martin Seebach
identifying failed disk/s in an array.,
Michael Harris
Problem with raid5 grow/resize (not restripe), Peter Rabbitson
AACRAID driver broken in 2.6.22.x (and beyond?) [WAS: Re: 2.6.22.16 MD raid1 doesn't mark removed disk faulty, MD thread goes UN],
Mike Snitzer
[PATCH] md: constify function pointer tables, Jan Engelhardt
Raid1, mdadm and nfs that remains in D state, BERTRAND Joël
2.6.22.16 MD raid1 doesn't mark removed disk faulty, MD thread goes UN,
Mike Snitzer
array doesn't run even with --force,
Carlos Carvalho
idle array consuming cpu ??!!,
Carlos Carvalho
One Large md or Many Smaller md for Better Peformance?,
Moshe Yudkowsky
Performance of RAID 10 vs. using LVM?, Moshe Yudkowsky
how to create a degraded raid1 with only 1 of 2 drives ??,
Mitchell Laks
mdadm error when trying to replace a failed drive in RAID5 array,
Steve Fairbairn
raid10 messed up filesystem, lvm lv ok,
Ask Bjørn Hansen
Raid 5 Wiederherstellung, Berny
3ware and dmraid - duplicate serial numbers (!),
Ask Bjørn Hansen
[PATCH 000 of 4] md: assorted md patched - please read carefully.,
NeilBrown
Incompatibility between Linux and Windows, Leopoldo Ghielmetti
Raid over 48 disks ... for real now,
Norman Elton
do_md_run returned -22 [Was: 2.6.24-rc8-mm1],
Jiri Slaby
The SX4 challenge,
Jeff Garzik
How do I get rid of old device?,
Justin Piszcz
Linux Software RAID 5 + XFS Multi-Benchmarks / 10 Raptors Again,
Justin Piszcz
[BUG] The kernel thread for md RAID1 could cause a md RAID1 array deadlock,
K.Tanaka
[RFC] A SCSI fault injection framework using SystemTap.,
K.Tanaka
Replacing an active drive., Greg Cormier
[PATCH 000 of 6] md: various fixes for md,
NeilBrown
The effects of multiple layers of block drivers,
Dennison Williams
trouble with mega-raid 150 and considering other alternatives, Eric S. Johansson
md rotates RAID5 spare at boot,
Jed Davidow
raid5 stuck in degraded, inactive and dirty mode,
CaT
Raid level 5 not permitted with --build, Daniel Browning
Is that normal a removed part in RAID0 still showed as "active sync",
Hxsrmeng
Raid 1, new disk can't be added after replacing faulty disk,
Radu Rendec
Why "mdadm --monitor --program" sometimes only gives 2 command-line arguments to the program?,
Hxsrmeng
Raid 1, can't get the second disk added back in.,
Jim
md raid1 in active-active arrangement, Clayton Bell
[PATCH] md: Fix data corruption when a degraded raid5 array is reshaped.,
NeilBrown
[Index of Archives]
[Linux RAID Wiki]
[Linux Block]
[ATA RAID]
[Kernel]
[Linux SCSI]
[Linux iSCSI]
[Linux SCSI Target Infrastructure]
[Linux Books]
