Linux IIO (Industrial I/O) Development
[Prev Page][Next Page]
- [PATCH v7 0/3] iio: chemical: atlas-sensor: add DO support,
Matt Ranostay
- [PATCH 0/2] iio: vcnl4000: Export near level property for proximity sensor,
Guido Günther
- [PATCH v5 0/7] Add support for Azoteq IQS620A/621/622/624/625,
Jeff LaBundy
- [PATCH AUTOSEL 5.5 068/542] iio: imu: st_lsm6dsx: check return value from st_lsm6dsx_sensor_set_enable, Sasha Levin
- [PATCH AUTOSEL 5.5 072/542] dt-bindings: iio: adc: ad7606: Fix wrong maxItems value, Sasha Levin
- [PATCH AUTOSEL 5.4 063/459] dt-bindings: iio: adc: ad7606: Fix wrong maxItems value, Sasha Levin
- [PATCH] iio: trigger: stm32-timer: disable master mode when stopping,
Fabrice Gasnier
- [PATCH v3] iio: trigger: stm32-timer: enable clock when in master mode,
Fabrice Gasnier
- [PATCH] iio: magnetometer: ak8974: Fix negative raw values in sysfs,
Stephan Gerhold
- [PATCH 0/5] iio: accel: adxl372: add peak mode,
Alexandru Tachici
- [PATCH v5 1/2] Driver for TI HDC20x0 humidity and temperature sensors,
Eugene Zalkonnikov
- [PATCH v3 0/2] iio: dac: AD5770R: Add support,
Alexandru Tachici
- [PATCH v3] iio: Add SEMTECH SX9310/9311 sensor driver,
Daniel Campello
- [PATCH 00/13] Rework sensors engines and power management,
Jean-Baptiste Maneyrol
- [PATCH 03/13] iio: imu: inv_mpu6050: set power on/off only once during all init, Jean-Baptiste Maneyrol
- [PATCH 02/13] iio: imu: inv_mpu6050: delete useless check, Jean-Baptiste Maneyrol
- [PATCH 01/13] iio: imu: inv_mpu6050: enable i2c aux mux bypass only once, Jean-Baptiste Maneyrol
- [PATCH 05/13] iio: imu: inv_mpu6050: early init of chip_config for use at setup, Jean-Baptiste Maneyrol
- [PATCH 06/13] iio: imu: inv_mpu6050: add all signal path resets at init, Jean-Baptiste Maneyrol
- [PATCH 07/13] iio: imu: inv_mpu6050: fix sleep time when turning regulators on, Jean-Baptiste Maneyrol
- [PATCH 08/13] iio: imu: inv_mpu6050: rewrite power and engine management, Jean-Baptiste Maneyrol
- [PATCH 10/13] iio: imu: inv_mpu6050: factorize fifo enable/disable, Jean-Baptiste Maneyrol
- [PATCH 11/13] iio: imu: inv_mpu6050: dynamic sampling rate change, Jean-Baptiste Maneyrol
- [PATCH 12/13] iio: imu: inv_mpu6050: use runtime pm with autosuspend, Jean-Baptiste Maneyrol
- [PATCH 13/13] iio: imu: inv_mpu6050: temperature only work with accel/gyro, Jean-Baptiste Maneyrol
- [PATCH 04/13] iio: imu: inv_mpu6050: simplify polling magnetometer, Jean-Baptiste Maneyrol
- [PATCH 09/13] iio: imu: inv_mpu6050: fix data polling interface, Jean-Baptiste Maneyrol
- [PATCH v3 0/5] iio: adc: ad7192: move out of staging,
Alexandru Tachici
- [PATCH v3 0/5] SFH: Add Support for AMD Sensor Fusion Hub,
Sandeep Singh
- [PATCH v5 0/7] iio: light: AL3010 introduction,
David Heidelberg
- [PATCH v2 0/6] irq/irq_sim: try to improve the API,
Bartosz Golaszewski
- [PATCH] counter: stm32-timer-cnt: remove iio headers,
Fabrice Gasnier
- [PATCH] iio: adc: Add imx8qxp adc driver support,
haibo . chen
- [PATCH V4] iio: adc: ad7124: Add direct reg access,
Mircea Caprioru
- [PATCH 1/2] iio: afe: rescale: Add support for converting scale avail table,
Paul Cercueil
- [PATCH v2] counter: stm32-timer-cnt: add power management support,
Fabrice Gasnier
- [PATCH v2 1/9] iio: imu: adis16480: initialize adis_data statically,
Alexandru Ardelean
- [PATCH v6 0/3] iio: chemical: atlas-sensor: add DO support,
Matt Ranostay
- [PATCH] dt-bindings: iio: adc: max1363 etc i2c ADC binding conversion,
jic23
- [PATCH] RFT: iio: gp2ap002: Replace LUT with math,
Linus Walleij
- [PATCH v2] iio: trigger: stm32-timer: enable clock when in master mode,
Fabrice Gasnier
- [PATCH] iio: si1133: read 24 signed integer for measurement,
Maxime Roussin-Bélanger
[PATCH] iio: vncl4000: Fix early return in vcnl4200_set_power_state,
Guido Günther
[PATCH v5 0/3] iio: chemical: atlas-sensor: add DO support,
Matt Ranostay
[PATCH v2] iio: Add SEMTECH SX9310/9311 sensor driver,
Daniel Campello
[PATCH v5 1/5] iio: core: Handle 'dB' suffix in core,
Beniamin Bia
[PATCH v2 0/6] Add support of similar chips,
Jean-Baptiste Maneyrol
[PATCH 0/2] iio: dac: AD5770R: Add support,
Alexandru Tachici
[PATCH v4 0/3] iio: chemical: atlas-sensor: add DO support,
Matt Ranostay
[PATCH] iio: accel: mma8452: Expose temperature channel,
Dylan Howey
[PATCH v2 10/17] iio: cros_ec: Use cros_ec_cmd(),
Prashant Malani
[PATCH] counter: stm32-timer-cnt: add power management support,
Fabrice Gasnier
[PATCH 0/5] iio: light: vcnl4000: make some settings configurable,
Tomas Novotny
[PATCH v3 0/3] iio: chemical: atlas-sensor: add DO support,
Matt Ranostay
[PATCH] dt-bindings: iio: adc: ad7923: Add dt-bindings for AD7928,
Daniel Junho
[PATCH] dt-bindings: Fix paths in schema $id fields,
Rob Herring
[PATCH 0/4] iio: adc: stm32-dfsdm: add scale and offset support,
Olivier Moysan
[PATCH v4 0/7] AL3010 introduction,
David Heidelberg
[PATCH v2 1/2] dt-binding: iio: add NPCM ADC reset support,
Tomer Maimon
[PATCH v3 0/2] iio: vncl4000: Enable runtime pm for vcnl4200/4040,
Guido Günther
[PATCH v3 0/7] iio: light: AL3010 introduction,
David Heidelberg
[PATCH 00/17] platform/chrome: Replace cros_ec_cmd_xfer_status,
Prashant Malani
[PATCH v2 0/2] iio: vncl4000: Enable runtime pm for vcnl4200/4040,
Guido Günther
[PATCH 1/3] dt-bindings: iio: ltc2632: expand for ltc2636 support,
Uwe Kleine-König
IIO driver module doesn't load automatically on kernel 4.19,
Nick Burkitt
Temperature support for FXLS8471Q accelerometer,
Dylan Howey
[PATCH v4 0/5] Add hmc425a support,
Beniamin Bia
[PATCH V3] iio: adc: ad7124: Add direct reg access,
Mircea Caprioru
[PATCH v3 1/3] iio: amplifiers: hmc425a: Add support for HMC425A step attenuator with gpio interface,
Beniamin Bia
[RESEND PATCH V2] iio: adc: ad7124: Add direct reg access, Mircea Caprioru
[RESEND PATCH] iio: adc: ad7124: Add direct reg access,
Mircea Caprioru
[PATCH v2 0/4] SFH: Add Support for AMD Sensor Fusion Hub,
Sandeep Singh
[PATCH] iio: adc: ad7124: Add direct reg access,
Mircea Caprioru
[PATCH 0/7] iio: light: AL3010 introduction,
David Heidelberg
[PATCH v3 0/3] Enhancements to at91-sama5d2_adc driver,
Eugen.Hristev
vcnl3020 hwmon/proximity driver,
Ivan Mikhaylov
[PATCH v3 1/3] iio: frequency: adf4360: Add support for ADF4360 PLLs,
Alexandru Ardelean
[PATCH] iio: imu: st_lsm6dsx: Fix mismatched comments,
JieunKim
[PATCH v2 1/5] IIO: Ingenic JZ47xx: Add xlate cb to retrieve correct channel idx,
Artur Rojek
[PATCH 1/2 v6] iio: light: Add DT bindings for GP2AP002,
Linus Walleij
[PATCH 1/7] iio: light: al3320a slightly improve code formatting,
David Heidelberg
[PATCH] iio: buffer: align the size of scan bytes to size of the largest element, Lars Möllendorf
[PATCH] iio: adc: stm32-adc: fix runtime autosuspend delay when slow polling,
Fabrice Gasnier
[PATCH v4 1/2] Driver for TI HDC20x0 humidity and temperature sensors,
Eugene Zalkonnikov
[PATCH][V2] iio: ad5755: fix spelling mistake "to" -> "too" and grammar,
Colin King
[PATCH] dt-bindings: stm32: convert dfsdm to json-schema,
Olivier Moysan
[PATCH] iio: ad5755: fix spelling mistake "to" -> "too",
Colin King
[PATCH 0/2] staging: iio: adc: ad7192: move out of staging,
Alexandru Tachici
[PATCH v2 1/3] iio: frequency: adf4360: Add support for ADF4360 PLLs,
Alexandru Ardelean
[PATCH v2 1/3] iio: amplifiers: hmc425a: Add support for HMC425A step attenuator with gpio interface,
Beniamin Bia
[PATCH] iio: adc: ad7124: add 3db filter,
Alexandru Tachici
[PATCH] iio: Add SEMTECH SX9310/9311 sensor driver,
Daniel Campello
[PATCH 1/2 v5] iio: light: Add DT bindings for GP2AP002,
Linus Walleij
[PATCH][next] iio: st_sensors: handle memory allocation failure to fix null pointer dereference,
Colin King
[PATCH 1/3] iio: frequency: adf4360: Add support for ADF4360 PLLs,
Alexandru Ardelean
[PATCH] iio: adc: stm32-dfsdm: fix sleep in atomic context,
Olivier Moysan
[PATCH v2 0/3] mfd: rn5t618: add ADC support,
Andreas Kemnade
[PATCH v3 2/2] iio: srf04: add power management feature,
Andreas Klinger
[PATCH v3 1/2] dt-bindings: devantech-srf04.yaml: add pm feature,
Andreas Klinger
[PATCH v3 0/2] iio: srf04: add support for power management, Andreas Klinger
[PATCH 0/2] iio: vncl4000: Enable runtime pm for vcnl4200/4040,
Guido Günther
[PATCH 1/4] iio: imu: adis: Add self_test_reg variable,
Alexandru Ardelean
[PATCH 0/9] Add support of similar chips,
Jean-Baptiste Maneyrol
[PATCH v1] iio: accel: st_accel: Use st_sensors_dev_name_probe(),
Andy Shevchenko
[PATCH v1 1/2] dt-binding: iio: add NPCM ADC reset support,
Tomer Maimon
Re: [PATCH v1 1/2] dt-binding: iio: add NPCM ADC reset support, Rob Herring
[PULL] Second set of IIO new device support, cleanups and minor fixes for the 5.6 cycle.,
Jonathan Cameron
[PATCH 0/5] mfd: rn5t618: add ADC support,
Andreas Kemnade
[PATCH v4 0/7] Add support for Azoteq IQS620A/621/622/624/625,
Jeff LaBundy
[Index of Archives]
[Linux USB Devel]
[Video for Linux]
[Big List of Linux Books]
[Linux SCSI]
[Yosemite Forum]
