On Sun, 9 Feb 2020 16:10:56 -0800
Matt Ranostay <matt.ranostay@xxxxxxxxxxxx> wrote:
> Sensors don't actually need a interrupt line to give valid readings,
> and can triggered with CONFIG_IIO_HRTIMER_TRIGGER as well. Remove
> the required check for interrupt, and continue along in the probe
> function.
>
> Signed-off-by: Matt Ranostay <matt.ranostay@xxxxxxxxxxxx>
Hi Matt,
I'm going to hold this for conclusion of the discussion about whether
the interrupt enable / disable should be related to the buffer or the trigger.
(v4 I think...)
Thanks,
Jonathan
> ---
> drivers/iio/chemical/atlas-sensor.c | 27 ++++++++++++---------------
> 1 file changed, 12 insertions(+), 15 deletions(-)
>
> diff --git a/drivers/iio/chemical/atlas-sensor.c b/drivers/iio/chemical/atlas-sensor.c
> index 2f0a6fed2589..9a1ab9f8fcc5 100644
> --- a/drivers/iio/chemical/atlas-sensor.c
> +++ b/drivers/iio/chemical/atlas-sensor.c
> @@ -572,11 +572,6 @@ static int atlas_probe(struct i2c_client *client,
> if (ret)
> return ret;
>
> - if (client->irq <= 0) {
> - dev_err(&client->dev, "no valid irq defined\n");
> - return -EINVAL;
> - }
> -
> ret = chip->calibration(data);
> if (ret)
> return ret;
> @@ -596,16 +591,18 @@ static int atlas_probe(struct i2c_client *client,
>
> init_irq_work(&data->work, atlas_work_handler);
>
> - /* interrupt pin toggles on new conversion */
> - ret = devm_request_threaded_irq(&client->dev, client->irq,
> - NULL, atlas_interrupt_handler,
> - IRQF_TRIGGER_RISING |
> - IRQF_TRIGGER_FALLING | IRQF_ONESHOT,
> - "atlas_irq",
> - indio_dev);
> - if (ret) {
> - dev_err(&client->dev, "request irq (%d) failed\n", client->irq);
> - goto unregister_buffer;
> + if (client->irq > 0) {
> + /* interrupt pin toggles on new conversion */
> + ret = devm_request_threaded_irq(&client->dev, client->irq,
> + NULL, atlas_interrupt_handler,
> + IRQF_TRIGGER_RISING |
> + IRQF_TRIGGER_FALLING | IRQF_ONESHOT,
> + "atlas_irq",
> + indio_dev);
> +
> + if (ret)
> + dev_warn(&client->dev,
> + "request irq (%d) failed\n", client->irq);
> }
>
> ret = atlas_set_powermode(data, 1);
