Linux Kernel I2C Bus Layer
[Prev Page][Next Page]
- Re: [PATCH v1 1/5] dt-bindings: dmaengine: qcom: gpi: Add additional arg to dma-cell property, (continued)
- [PATCH v1 0/2] riscv: spacemit: add i2c support to K1 SoC,
Troy Mitchell
- [PATCH v5 0/3] i2c: imx: prevent rescheduling in non-dma mode,
Stefan Eichenberger
- [PATCH v2] i2c: i2c-qcom-geni: Serve transfer during early resume stage,
Mukesh Kumar Savaliya
- [PATCH 0/2] Add atomic transfer support to i2c-xiic,
Manikanta Guntupalli
- i2c-tools 4.4 has been released, Jean Delvare
- [PATCH 1/1] MAINTAINERS: Add an entry for the LJCA drivers,
Sakari Ailus
- [PATCH v6 0/4] i2c: npcm: read/write operation, checkpatch,
Tyrone Ting
- [PATCH v10 0/2] i2c: octeon: Add block-mode r/w,
Aryan Srivastava
- [PATCH v3 0/6] i2c: nomadik: support >=1MHz & Mobileye EyeQ6H platform,
Théo Lebrun
- [PATCH v2 0/6] i2c: nomadik: support >=1MHz & Mobileye EyeQ6H platform,
Théo Lebrun
- [PATCH] i2c: qup: use generic device property accessors,
Bartosz Golaszewski
- [PATCH 0/4] i2c: nomadik: support >=1MHz & Mobileye EyeQ6H platform,
Théo Lebrun
- [PATCH v8 0/8] platform/chrome: Introduce DT hardware prober,
Chen-Yu Tsai
- [PATCH 0/3] i2c: i801: Use MMIO if available,
Heiner Kallweit
- [PATCH v15 0/3] Add ASPEED AST2600 I2Cv2 controller driver,
Ryan Chen
- [PATCH v9 0/2] i2c: octeon: Add block-mode r/w,
Aryan Srivastava
- [PULL REQUEST] i2c-for-6.12-rc2,
Wolfram Sang
- [PATCH AUTOSEL 4.19 10/16] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 5.4 12/21] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 5.10 15/26] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 5.15 18/31] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 6.1 19/42] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 6.6 25/58] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 6.10 27/70] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [PATCH AUTOSEL 6.11 28/76] i2c: i801: Use a different adapter-name for IDF adapters, Sasha Levin
- [GIT PULL] i2c-host-fixes for v6.12-rc2,
Andi Shyti
- [PATCH 00/51] treewide: Switch to __pm_runtime_put_autosuspend(),
Sakari Ailus
- [PATCH v4 0/2] Compute HS HCNT and LCNT based on HW parameters,
Michael Wu
- [PATCH v4 0/4] i2c: imx: prevent rescheduling in non-dma mode,
Stefan Eichenberger
- 回收: [PATCH v3 1/2] dt-bindings: i2c: snps,designware-i2c: declare bus capacitance and clk freq optimized,
Michael Wu
- [no subject], Unknown
- [PATCH v14 0/3] Add ASPEED AST2600 I2Cv2 controller driver,
Ryan Chen
- [PATCH v2] i2c: qcom-geni: Keep comment why interrupts start disabled,
Andi Shyti
- [PATCH v3 0/5] Congatec Board Controller drivers,
Thomas Richard
- [PATCH v3 0/2] Compute HS HCNT and LCNT based on HW parameters,
Michael Wu
- [PATCH v5 0/6] i2c: npcm: read/write operation, checkpatch,
Tyrone Ting
- [PATCH v5 0/7] Add SDM670 camera subsystem,
Richard Acayan
- [PATCH v5 1/7] dt-bindings: clock: qcom,sdm845-camcc: add sdm670 compatible, Richard Acayan
- [PATCH v5 2/7] dt-bindings: i2c: qcom-cci: Document SDM670 compatible, Richard Acayan
- [PATCH v5 3/7] i2c: qcom-cci: Stop complaining about DT set clock rate, Richard Acayan
- [PATCH v5 4/7] dt-bindings: media: camss: Add qcom,sdm670-camss, Richard Acayan
- [PATCH v5 5/7] media: qcom: camss: add support for SDM670 camss, Richard Acayan
- [PATCH v5 6/7] arm64: dts: qcom: sdm670: add camcc, Richard Acayan
- [PATCH v5 7/7] arm64: dts: qcom: sdm670: add camss and cci, Richard Acayan
- Re: [PATCH v5 0/7] Add SDM670 camera subsystem, Andi Shyti
- [PATCH v2] i2c: stm32f7: Do not prepare/unprepare clock during runtime suspend/resume,
Marek Vasut
- [PATCH v3 1/1] i2c: qcom-geni: Support systems with 32MHz serial engine clock,
Manikanta Mylavarapu
- [PATCH v1] i2c: microchip-core: actually use repeated sends,
Conor Dooley
- [linux][PATCH v2 10/20] dt-bindings: i2c: microchip: corei2c: Add PIC64GX as compatible with driver,
pierre-henry.moussay
- [PULL REQUEST] i2c-for-6.12-rc1-additional_fixes,
Wolfram Sang
- [PATCH] i2c: Switch back to struct platform_driver::remove(),
Uwe Kleine-König
- [PATCH] i2c: stm32f7: Do not prepare/unprepare clock during runtime suspend/resume,
Marek Vasut
- [GIT PULL v2] i2c-host-fixes for v6.12-rc1, Andi Shyti
- Re: [PATCH] i2c: amd-asf: Fix uninitialized variables issue in amd_asf_process_target,
Dan Carpenter
- Message not available
- Message not available
[GIT PULL] i2c-host-fixes for v6.12-rc1,
Andi Shyti
[PATCH v3 0/4] Enable shared SE support over I2C,
Mukesh Kumar Savaliya
[PATCH v2 0/2] Compute HS HCNT and LCNT based on HW parameters,
Michael Wu
[PATCH v8 0/2] i2c: octeon: Add block-mode r/w,
Aryan Srivastava
[PATCH v2 0/2] i2c: Add ACPI support for HJMC01,
hunter.yu
[PATCH v2 1/1] i2c: qcom-geni: Support systems with 32MHz serial engine clock,
Manikanta Mylavarapu
[PATCH v5 0/6] RTL9300 support for reboot and i2c,
Chris Packham
[PATCH v1 0/5] i2c: designware: Cleanups (part 4),
Andy Shevchenko
[PATCH 0/2] Compute HS HCNT and LCNT based on HW parameters,
Michael Wu
[PATCH] i2c: I2C_KEBA should depend on KEBA_CP500,
Geert Uytterhoeven
Re: [PATCH] i2c: I2C_KEBA should depend on KEBA_CP500, Andi Shyti
[PATCH 1/1] i2c: qcom-geni: add 32MHz I2C SE clock support for IPQ5424,
Manikanta Mylavarapu
[PATCH v3 0/3] i2c: RTL9300 support,
Chris Packham
[PATCH] i2c: i801: Add support for Intel Panther Lake,
Jarkko Nikula
[PATCH v7 0/8] Introduce initial AMD ASF Controller driver support,
Shyam Sundar S K
[PULL REQUEST] i2c-for-6.12-rc1,
Wolfram Sang
[PATCH] i2c: xiic: Fix pm_runtime_set_suspended() with runtime pm enabled,
Jinjie Ruan
[PATCH v2 0/3] hwmon: pmbus: add tps25990 efuse support,
Jerome Brunet
[v1,0/1] i2c: mediatek: add runtime PM operations and bus regulator control,
zoie.lin
imx8mm - sbs-battery problem, Weber, Thomas
[PATCH v4 0/6] i2c: npcm: read/write operation, checkpatch,
warp5tw
[PATCH v2 0/3] i2c: RTL9300 support,
Chris Packham
[PATCH v6 0/8] Introduce initial AMD ASF Controller driver support,
Shyam Sundar S K
[PATCH 2/2] i2c: designware: Add a new ACPI HID for HJMC01 I2C controller,
hunter . yu
[PULL REQUEST] i2c-for-6.11-final-but-missed-it,
Wolfram Sang
[PATCH 1/2] ACPI: APD: Add clock frequency for HJMC01 I2C controller,
hunter . yu
[PATCH 0/5] i2c: RTL9300 support,
Chris Packham
[PATCH v2 0/5] Congatec Board Controller drivers,
Thomas Richard
Query regarding i2c-scmi not creating the right adapter, Andrea Costanzo
[PATCH v4 0/8] Add support for GE SUNH hot-pluggable connector,
Luca Ceresoli
[PATCH] i2c: qcom-geni: Keep comment why interrupts start disabled,
Wolfram Sang
[PATCH v2 00/11] i2c: isch: Put the driver into shape,
Andy Shevchenko
- [PATCH v2 03/11] i2c: isch: Switch to memory mapped IO accessors, Andy Shevchenko
- [PATCH v2 04/11] i2c: isch: Use custom private data structure, Andy Shevchenko
- [PATCH v2 02/11] i2c: isch: Use string_choices API instead of ternary operator, Andy Shevchenko
- [PATCH v2 09/11] i2c: isch: Don't use "proxy" headers, Andy Shevchenko
- [PATCH v2 11/11] i2c: isch: Convert to kernel-doc, Andy Shevchenko
- [PATCH v2 07/11] i2c: isch: Use read_poll_timeout(), Andy Shevchenko
- [PATCH v2 08/11] i2c: isch: Unify the name of the variable to hold an error code, Andy Shevchenko
- [PATCH v2 01/11] i2c: isch: Pass pointer to struct i2c_adapter down, Andy Shevchenko
- [PATCH v2 06/11] i2c: isch: Utilize temporary variable to hold device pointer, Andy Shevchenko
- [PATCH v2 05/11] i2c: isch: switch i2c registration to devm functions, Andy Shevchenko
- [PATCH v2 10/11] i2c: isch: Prefer to use octal permission, Andy Shevchenko
- Re: [PATCH v2 00/11] i2c: isch: Put the driver into shape, Andi Shyti
[no subject], Unknown
[PATCH v5 0/8] Introduce initial AMD ASF Controller driver support,
Shyam Sundar S K
[GIT PULL] i2c-host for v6.12,
Andi Shyti
[PATCH v4 2/2] pca954x: Reset if channel select fails, Wojciech Siudy (Nokia)
[PATCH v4 1/2] dt-bindings: i2c: pca954x: Add timeout reset property,
Wojciech Siudy (Nokia)
[PATCH v4 0/2] pca954x: Add DT bindings and driver changes for reset after timeout,
Wojciech Siudy (Nokia)
[PATCH v3 6/6] i2c: npcm: Enable slave in eob interrupt,
Tyrone Ting
[PATCH v3 0/6] i2c: npcm: Bug fixes read/write operation, checkpatch,
warp5tw
[Index of Archives]
[Linux USB Devel]
[Video for Linux]
[Big List of Linux Books]
[Linux SCSI]
[Yosemite Forum]
