On 04/12/2024 16:03, Viken Dadhaniya wrote: > Document the 'qcom,load-firmware' and 'qcom,xfer-mode' properties to > support SE(Serial Engine) firmware loading from the protocol driver and to > select the data transfer mode, either GPI DMA (Generic Packet Interface) > or non-GPI mode (PIO/CPU DMA). > > UART controller can operate in one of two modes based on the > 'qcom,xfer-mode' property, and the firmware is loaded accordingly. > > Co-developed-by: Mukesh Kumar Savaliya <quic_msavaliy@xxxxxxxxxxx> > Signed-off-by: Mukesh Kumar Savaliya <quic_msavaliy@xxxxxxxxxxx> > Signed-off-by: Viken Dadhaniya <quic_vdadhani@xxxxxxxxxxx> > --- My comments from I2C patch apply here, but let's keep discussion there. Responding here just for formality. Best regards, Krzysztof
