Linux Kernel I2C Bus Layer
[Prev Page][Next Page]
- [PATCH 03/24] dt-bindings: pwrap: mediatek: add pwrap support for MT8516, (continued)
- [PATCH 0/5] i2c: match filenames for drivers and bindings,
Wolfram Sang
- [PATCH v3] i2c: at91: Convert to use struct i2c_timings,
Andy Shevchenko
- [PATCH] dt-bindings: at24: add Renesas R1EX24016,
Geert Uytterhoeven
- [PATCH] i2c: riic: Add Runtime PM support,
Geert Uytterhoeven
- [PATCH v2] i2c: at91: Convert to use struct i2c_timings, Andy Shevchenko
- [PATCH v2] i2c: i801: Add support for Intel Comet Lake,
Jarkko Nikula
- [PATCH] i2c: i801: Add support for Intel Comet Lake,
Jarkko Nikula
- [PATCH v7 0/3] i2c: improve i2c_new_{device|dummy},
Wolfram Sang
- [PATCH v1] i2c: base: Drop unneeded checks for of_node,
Andy Shevchenko
- [PATCH v2 1/2] i2c: i2c-designware-platdrv: Cleanup setting of the adapter number,
Hans de Goede
- [PATCH v2] i2c: add extra check to safe DMA buffer helper,
Wolfram Sang
- I2C IRQ acquisition refactor follow-up,
Jim Broadus
- [PATCH i2c-tools 0/2] tools: improvements to handling restricted addresses,
Wolfram Sang
- [PATCH AUTOSEL 4.20 48/52] i2c: cadence: Fix the hold bit setting, Sasha Levin
- [PATCH AUTOSEL 4.20 49/52] i2c: bcm2835: Clear current buffer pointers and counts after a transfer, Sasha Levin
- [PATCH AUTOSEL 4.19 41/44] i2c: cadence: Fix the hold bit setting, Sasha Levin
- [PATCH AUTOSEL 4.19 42/44] i2c: bcm2835: Clear current buffer pointers and counts after a transfer, Sasha Levin
- [PATCH AUTOSEL 4.14 24/27] i2c: cadence: Fix the hold bit setting, Sasha Levin
- [PATCH AUTOSEL 4.14 25/27] i2c: bcm2835: Clear current buffer pointers and counts after a transfer, Sasha Levin
- [PATCH AUTOSEL 4.9 11/12] i2c: cadence: Fix the hold bit setting, Sasha Levin
- [PATCH AUTOSEL 4.4 7/8] i2c: cadence: Fix the hold bit setting, Sasha Levin
- [PATCH AUTOSEL 3.18 5/6] i2c: cadence: Fix the hold bit setting, Sasha Levin
- [PATCH 0/2] intel-lpss-pci-i2c: Fix oops when there is no ACPI fwnode,
Hans de Goede
- [PATCH] i2c: Do _not_ clear client->irq on remove if the irq comes from the board_info,
Hans de Goede
- [PATCH v6 0/6] add i2c support for mt8183,
Qii Wang
- [PATCH] i2c: add extra check to safe DMA buffer helper,
Wolfram Sang
- [PATCH v2 0/5] i2c: mux: pca9541: extend with support for pca9641,
Peter Rosin
- [PATCH v2 1/5] i2c: mux: pca9541: use the BIT macro, Peter Rosin
- [PATCH v2 3/5] i2c: mux: pca9541: prepare for PCA9641 support, Peter Rosin
[PATCH] i2c: i2c-stm32f7: improve loopback in timing algorithm,
Bich HEMON
[PATCH] i2c: i2c-stm32f7: Fix SDADEL minimum formula,
Bich HEMON
[PATCH 0/2] Patches for i2c-stm32 device tree bindings,
Bich HEMON
[PULL REQUEST] i2c for 5.1,
Wolfram Sang
[PATCH 0/3] i2c: rcar: make DMA more robust,
Wolfram Sang
[PATCH v17] i2c: Add drivers for the AMD PCIe MP2 I2C controller,
Elie Morisse
[PATCH 0/2] i2c: rcar: improve concurrency,
Wolfram Sang
[PATCH] i2c: sis630: correct format strings,
Louis Taylor
[RFC PATCH v2 0/7] i2c: core: introduce atomic transfers,
Wolfram Sang
[PATCH AUTOSEL 4.20 70/81] i2c: omap: Use noirq system sleep pm ops to idle device for suspend, Sasha Levin
[PATCH AUTOSEL 4.19 56/64] i2c: omap: Use noirq system sleep pm ops to idle device for suspend, Sasha Levin
[PATCH AUTOSEL 4.14 33/36] i2c: omap: Use noirq system sleep pm ops to idle device for suspend, Sasha Levin
[PATCH v5 0/2] i2c: designware: Add support for a bus clock,
Gareth Williams
[PATCH v4 0/3] i2c: mux: pca954x: allow management of device idle state via sysfs,
Robert Shearman
[PATCH] i2c: imx: add support for I2C_M_STOP flag,
Mans Rullgard
[PATCH v16] i2c: Add drivers for the AMD PCIe MP2 I2C controller,
Elie Morisse
[PATCH v5 0/5] add i2c support for mt8183,
Qii Wang
[PATCH v3 0/3] i2c: mux: pca954x: allow management of device idle state via sysfs,
Robert Shearman
[PATCHv4] i2c: cadence: Fix the driver in interrupt flurry case,
shubhrajyoti.datta
[PATCH] mfd: twl-core: disable irq while suspended,
Andreas Kemnade
[PATCH v2 0/1] i2c: designware: Do not allow i2c_dw_xfer() calls while,
Hans de Goede
[PATCH v5 0/3] i2c: at91: slave mode support,
Ludovic Desroches
[PATCH v4 0/2] i2c: designware: Add support for a bus clock,
Gareth Williams
[PATCH] i2c: tegra: Only display error messages if DMA setup fails,
Jon Hunter
[PATCH v3 0/2] i2c: designware: Add support for a bus clock,
Gareth Williams
[PATCH v4 0/3] add i2c support for mt8183,
Qii Wang
[PATCHv3] i2c: cadence: Fix the driver in interrupt flurry case,
shubhrajyoti.datta
[PATCHv2] i2c: cadence: Fix the driver in interrupt flurry case,
shubhrajyoti.datta
[PATCH v4 0/2] i2c: added driver for Mellanox BlueField SoC,
Khalil Blaiech
[PATCH V5 1/2] i2c: tegra: remove master fifo support on tegra186,
Sowjanya Komatineni
[PATCH v2 0/2] i2c: gpio: fault-injector: add two new injectors,
Wolfram Sang
[PATCH v2 0/2] dt: i2c: Add support for bus clock,
Gareth Williams
[PATCH V4 1/2] i2c: tegra: remove master fifo support on tegra186,
Sowjanya Komatineni
[PATCH v2] i2c: cadence: try reset when master receive arbitration lost,
Shikai Wang
[PATCH V3] i2c: tegra: fix tegra186 hw feature support, Sowjanya Komatineni
[PATCH V2] i2c: tegra: fix tegra186 hw feature support for has_mst_fifo_reg,
Sowjanya Komatineni
[PATCH] i2c: cadence: try reset when master receive arbitration lost,
sxauwsk
[PATCH 0/2] i2c: gpio: fault-injector: add two new injectors,
Wolfram Sang
[PATCH] eeprom at24: Remove unnecessary AT24_CHIP_DATA for INT3499,
Adrian Bunk
[4.9/4.14 patch v2 0/2] at24: add support for 24c2048,
Adrian Bunk
[PATCH V1] i2c: tegra: fix tegra186 hw supported features,
Sowjanya Komatineni
[PATCH] i2c: Allow recovery of the initial IRQ by a i2c client device.,
Jim Broadus
[PATCH][next] i2c: tegra: change phrasing, "fallbacking" to "falling back",
Colin King
[PATCH] i2c: cadence: Fix the driver in interrupt flurry case,
shubhrajyoti.datta
[PATCH] i2c: mediatek: modify threshold passed to i2c_get_dma_safe_msg_buf(),
Hsin-Yi Wang
Re: [PATCH] i2c: mediatek: modify threshold passed to i2c_get_dma_safe_msg_buf(), Wolfram Sang
[PATCH v5 0/8] iProc I2C slave mode and NIC mode,
Ray Jui
- [PATCH v5 1/8] i2c: iproc: Extend I2C read up to 255 bytes, Ray Jui
- [PATCH v5 3/8] dt-bindings: i2c: iproc: make 'interrupts' optional, Ray Jui
- [PATCH v5 4/8] i2c: iproc: add polling support, Ray Jui
- [PATCH v5 5/8] i2c: iproc: use wrapper for read/write access, Ray Jui
- [PATCH v5 6/8] dt-bindings: i2c: iproc: add "brcm,iproc-nic-i2c" compatible string, Ray Jui
- [PATCH v5 8/8] arm64: dts: Stingray: Add NIC i2c device node, Ray Jui
- [PATCH v5 7/8] i2c: iproc: add NIC I2C support, Ray Jui
- [PATCH v5 2/8] i2c: iproc: Add slave mode support, Ray Jui
- Re: [PATCH v5 0/8] iProc I2C slave mode and NIC mode, Ray Jui
- Re: [PATCH v5 0/8] iProc I2C slave mode and NIC mode, Wolfram Sang
[4.9/4.14 patch] eeprom: at24: add support for 24c2048,
Adrian Bunk
[GIT PULL] at24: updates for v5.1,
Bartosz Golaszewski
[PATCH v7 0/5] i2c: ocores: improvements,
Federico Vaga
[PATCH 0/2] i2c: ocores: IO registers and bus clock,
Andrew Lunn
[PATCH v2 resend] i2c: mux: pca954x: allow management of device idle state via sysfs,
Robert Shearman
[PATCH v3] i2c: core-smbus: don't trace smbus_reply data on errors,
John Sperbeck
[PATCH V19 1/7] i2c: tegra: sort all the include headers alphabetically,
Sowjanya Komatineni
[PATCH] i2c: expand minor range when registering chrdev region,
Chengguang Xu
[PATCH v2] i2c: aspeed: Add multi-master use case support,
Jae Hyun Yoo
[PATCH v6 0/5] i2c: ocores: improvements,
Federico Vaga
[PATCH v5 0/5] i2c:ocores: improvements,
Federico Vaga
[PATCH] i2c: document the SDA hold time binding,
Wolfram Sang
[RFC PATCH] i2c: ocores: turn incomplete kdoc into a comment,
Wolfram Sang
[PATCH v4 0/5] i2c:ocores: improvements,
Federico Vaga
[PULL REQUEST] i2c for v5.0,
Wolfram Sang
[PATCH V18 1/6] i2c: tegra: sort all the include headers alphabetically,
Sowjanya Komatineni
[PATCH V17 1/6] i2c: tegra: sort all the include headers alphabetically,
Sowjanya Komatineni
[PATCH] MAINTAINERS: Update the ocores i2c bus driver maintainer, etc,
Andrew Lunn
[PATCH V16 1/6] i2c: tegra: sort all the include headers alphabetically,
Sowjanya Komatineni
[PATCH v3 0/5],
Federico Vaga
[PATCH v3 0/4] i2c-ocores: Add IO mapped polled support,
Andrew Lunn
[PATCH V15 1/6] i2c: tegra: sort all the include headers alphabetically,
Sowjanya Komatineni
[Index of Archives]
[Linux USB Devel]
[Video for Linux]
[Big List of Linux Books]
[Linux SCSI]
[Yosemite Forum]
