Re: [PATCH V4] drivers: i2c: tegra: fix checkpatch defects

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



06.06.2019 17:02, Bitan Biswas пишет:
> 
> 
> On 6/6/19 4:39 AM, Dmitry Osipenko wrote:
>> 06.06.2019 10:35, Bitan Biswas пишет:
>>> Fix checkpatch.pl warning(s)/error(s)/check(s) in i2c-tegra.c
>>>
>>> Remove redundant BUG_ON calls or replace with WARN_ON_ONCE
>>> as needed. Replace BUG() with error handling code.
>>> Define I2C_ERR_UNEXPECTED_STATUS for error handling.
>>>
>>> Signed-off-by: Bitan Biswas <bbiswas@xxxxxxxxxx>
>>> ---
>>>   drivers/i2c/busses/i2c-tegra.c | 67
>>> +++++++++++++++++++++++-------------------
>>>   1 file changed, 37 insertions(+), 30 deletions(-)
>>>
>>> diff --git a/drivers/i2c/busses/i2c-tegra.c
>>> b/drivers/i2c/busses/i2c-tegra.c
>>> index 76b7926..55a5d87 100644
>>> --- a/drivers/i2c/busses/i2c-tegra.c
>>> +++ b/drivers/i2c/busses/i2c-tegra.c
>>> @@ -78,6 +78,7 @@
>>>   #define I2C_ERR_NO_ACK                0x01
>>>   #define I2C_ERR_ARBITRATION_LOST        0x02
>>>   #define I2C_ERR_UNKNOWN_INTERRUPT        0x04
>>> +#define I2C_ERR_UNEXPECTED_STATUS               0x08
>>>     #define PACKET_HEADER0_HEADER_SIZE_SHIFT    28
>>>   #define PACKET_HEADER0_PACKET_ID_SHIFT        16
>>> @@ -112,7 +113,7 @@
>>>   #define I2C_CLKEN_OVERRIDE            0x090
>>>   #define I2C_MST_CORE_CLKEN_OVR            BIT(0)
>>>   -#define I2C_CONFIG_LOAD_TIMEOUT            1000000
>>> +#define I2C_CONFIG_LOAD_TMOUT            1000000
>>>     #define I2C_MST_FIFO_CONTROL            0x0b4
>>>   #define I2C_MST_FIFO_CONTROL_RX_FLUSH        BIT(0)
>>> @@ -280,6 +281,7 @@ struct tegra_i2c_dev {
>>>       u32 bus_clk_rate;
>>>       u16 clk_divisor_non_hs_mode;
>>>       bool is_multimaster_mode;
>>> +    /* xfer_lock: lock to serialize transfer submission and
>>> processing */
>>>       spinlock_t xfer_lock;
>>>       struct dma_chan *tx_dma_chan;
>>>       struct dma_chan *rx_dma_chan;
>>> @@ -306,7 +308,7 @@ static u32 dvc_readl(struct tegra_i2c_dev
>>> *i2c_dev, unsigned long reg)
>>>    * to the I2C block inside the DVC block
>>>    */
>>>   static unsigned long tegra_i2c_reg_addr(struct tegra_i2c_dev *i2c_dev,
>>> -    unsigned long reg)
>>> +                    unsigned long reg)
>>>   {
>>>       if (i2c_dev->is_dvc)
>>>           reg += (reg >= I2C_TX_FIFO) ? 0x10 : 0x40;
>>> @@ -314,7 +316,7 @@ static unsigned long tegra_i2c_reg_addr(struct
>>> tegra_i2c_dev *i2c_dev,
>>>   }
>>>     static void i2c_writel(struct tegra_i2c_dev *i2c_dev, u32 val,
>>> -    unsigned long reg)
>>> +               unsigned long reg)
>>>   {
>>>       writel(val, i2c_dev->base + tegra_i2c_reg_addr(i2c_dev, reg));
>>>   @@ -329,13 +331,13 @@ static u32 i2c_readl(struct tegra_i2c_dev
>>> *i2c_dev, unsigned long reg)
>>>   }
>>>     static void i2c_writesl(struct tegra_i2c_dev *i2c_dev, void *data,
>>> -    unsigned long reg, int len)
>>> +            unsigned long reg, int len)
>>>   {
>>>       writesl(i2c_dev->base + tegra_i2c_reg_addr(i2c_dev, reg), data,
>>> len);
>>>   }
>>>     static void i2c_readsl(struct tegra_i2c_dev *i2c_dev, void *data,
>>> -    unsigned long reg, int len)
>>> +               unsigned long reg, int len)
>>>   {
>>>       readsl(i2c_dev->base + tegra_i2c_reg_addr(i2c_dev, reg), data,
>>> len);
>>>   }
>>> @@ -486,7 +488,7 @@ static int tegra_i2c_flush_fifos(struct
>>> tegra_i2c_dev *i2c_dev)
>>>               dev_warn(i2c_dev->dev, "timeout waiting for fifo
>>> flush\n");
>>>               return -ETIMEDOUT;
>>>           }
>>> -        msleep(1);
>>> +        usleep_range(1000, 2000);
>>>       }
>>>       return 0;
>>>   }
>>> @@ -525,7 +527,6 @@ static int tegra_i2c_empty_rx_fifo(struct
>>> tegra_i2c_dev *i2c_dev)
>>>        * prevent overwriting past the end of buf
>>>        */
>>>       if (rx_fifo_avail > 0 && buf_remaining > 0) {
>>> -        BUG_ON(buf_remaining > 3);
>>>           val = i2c_readl(i2c_dev, I2C_RX_FIFO);
>>>           val = cpu_to_le32(val);
>>>           memcpy(buf, &val, buf_remaining);
>>> @@ -533,7 +534,6 @@ static int tegra_i2c_empty_rx_fifo(struct
>>> tegra_i2c_dev *i2c_dev)
>>>           rx_fifo_avail--;
>>>       }
>>>   -    BUG_ON(rx_fifo_avail > 0 && buf_remaining > 0);
>>>       i2c_dev->msg_buf_remaining = buf_remaining;
>>>       i2c_dev->msg_buf = buf;
>>>   @@ -591,7 +591,6 @@ static int tegra_i2c_fill_tx_fifo(struct
>>> tegra_i2c_dev *i2c_dev)
>>>        * boundary and fault.
>>>        */
>>>       if (tx_fifo_avail > 0 && buf_remaining > 0) {
>>> -        BUG_ON(buf_remaining > 3);
>>>           memcpy(&val, buf, buf_remaining);
>>>           val = le32_to_cpu(val);
>>>   @@ -680,10 +679,11 @@ static int
>>> tegra_i2c_wait_for_config_load(struct tegra_i2c_dev *i2c_dev)
>>>           i2c_writel(i2c_dev, I2C_MSTR_CONFIG_LOAD, I2C_CONFIG_LOAD);
>>>           if (in_interrupt())
>>>               err = readl_poll_timeout_atomic(addr, val, val == 0,
>>> -                    1000, I2C_CONFIG_LOAD_TIMEOUT);
>>> +                            1000,
>>> +                            I2C_CONFIG_LOAD_TMOUT);
>>>           else
>>> -            err = readl_poll_timeout(addr, val, val == 0,
>>> -                    1000, I2C_CONFIG_LOAD_TIMEOUT);
>>> +            err = readl_poll_timeout(addr, val, val == 0, 1000,
>>> +                         I2C_CONFIG_LOAD_TMOUT);
>>>             if (err) {
>>>               dev_warn(i2c_dev->dev,
>>> @@ -858,16 +858,21 @@ static irqreturn_t tegra_i2c_isr(int irq, void
>>> *dev_id)
>>>           if (i2c_dev->msg_read && (status &
>>> I2C_INT_RX_FIFO_DATA_REQ)) {
>>>               if (i2c_dev->msg_buf_remaining)
>>>                   tegra_i2c_empty_rx_fifo(i2c_dev);
>>> -            else
>>> -                BUG();
>>> +            else {
>>> +                dev_err(i2c_dev->dev, "unexpected rx data request\n");
>>> +                i2c_dev->msg_err |= I2C_ERR_UNEXPECTED_STATUS;
>>> +                goto err;
>>> +            }
>>>           }
>>>             if (!i2c_dev->msg_read && (status &
>>> I2C_INT_TX_FIFO_DATA_REQ)) {
>>> -            if (i2c_dev->msg_buf_remaining)
>>> -                tegra_i2c_fill_tx_fifo(i2c_dev);
>>> -            else
>>> +            if (i2c_dev->msg_buf_remaining) {
>>> +                if (tegra_i2c_fill_tx_fifo(i2c_dev))
>>> +                    goto err;
>>> +            } else {
>>>                   tegra_i2c_mask_irq(i2c_dev,
>>>                              I2C_INT_TX_FIFO_DATA_REQ);
>>> +            }
>>>           }
>>>       }
>>>   @@ -885,7 +890,7 @@ static irqreturn_t tegra_i2c_isr(int irq, void
>>> *dev_id)
>>>       if (status & I2C_INT_PACKET_XFER_COMPLETE) {
>>>           if (i2c_dev->is_curr_dma_xfer)
>>>               i2c_dev->msg_buf_remaining = 0;
>>> -        BUG_ON(i2c_dev->msg_buf_remaining);
>>> +        WARN_ON_ONCE(i2c_dev->msg_buf_remaining);
>>>           complete(&i2c_dev->msg_complete);
>>>       }
>>>       goto done;
>>> @@ -1024,7 +1029,7 @@ static int tegra_i2c_issue_bus_clear(struct
>>> i2c_adapter *adap)
>>>   }
>>>     static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
>>> -    struct i2c_msg *msg, enum msg_end_type end_state)
>>> +                  struct i2c_msg *msg, enum msg_end_type end_state)
>>>   {
>>>       u32 packet_header;
>>>       u32 int_mask;
>>> @@ -1034,7 +1039,7 @@ static int tegra_i2c_xfer_msg(struct
>>> tegra_i2c_dev *i2c_dev,
>>>       u32 *buffer = NULL;
>>>       int err = 0;
>>>       bool dma;
>>> -    u16 xfer_time = 100;
>>> +    u16 xfer_tm = 100;
>>
>> Why xfer_time is renamed? It is much more important to keep code
>> readable rather than to satisfy checkpatch. You should *not* follow
>> checkpatch recommendations where they do not make much sense. The
>> xfer_tm is a less intuitive naming and hence it harms readability of the
>> code. Hence it is better to have "lines over 80 chars" in this
>> particular case.
> Agreed. I shall share updated patch.

Yes, please.

>>
>> Also, please don't skip review comments. I already pointed out the above
>> in the answer to previous version of the patch.
>>
> I apologize for the oversight. I shall be more careful in future.

No problems ;)



[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux