On 4/10/2024 10:13 AM, Krzysztof Kozlowski wrote:
On 10/04/2024 18:55, Nikunj Kela wrote:
If there are no more questions on this and everyone is on the same page,
I would like to conclude this thread in favor of using a new DT property
'qcom,firmware-managed-resources'.
Just to recap my earlier statement, because I am not sure if I got the
answer (if answer was provided, then I don't forgot... sorry):
This is a new hardware, so you have a new compatible, therefore any
additional property is not needed.
This is not a new HW, this is the same HW with different FW and
interface to FW is different too. As you can see earlier discussion on
this thread, new compatible was ruled out since it is the same HW IP.
In other cases, just use existing properties, don't bring a third one. :/
Not sure which existing property you are referring to. There is no
property to the best of my knowledge to deal with our scenario. Are you
suggesting we reuse "qcom,controlled-remotely" property that is used in
Qualcomm BAM DMA Controller for our case too?
Best regards,
Krzysztof
