Re: Dposh DVB-T USB2.0 seems to not work properly

["Andrew Websdale" <websdaleandrew@xxxxxxxxxxxxxx>]

2008/6/24 Antti Palosaari <crope@xxxxxx>:

ma 23.6.2008 21:58 Andrew Websdale kirjoitti:

>> I've tried adding the mt2060 code - it compiles OK & does seem to be
>> nearly
>> right,the tuner is being recognised, but I think loading the module
>> causes
>> the I2c bit of the kernel to Oops - would an incorrect i2c address cause
>> this?
>>
> Here's my dmesg output:

> m920x_mt2060_tuner_attach
> BUG: unable to handle kernel NULL pointer dereference at virtual address
> 0000006c

because you have passed tuner i2c-address as parameter to the dvb_attach()

I've changed the parameter to '&adap->dev->i2c_adap' & I now get this dmesg output:

dvb-usb: found a 'Dposh(mt2060 tuner) DVB-T USB2.0' in cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-dposh-01.fw'
80 0 b0 0
ff
firmware uploaded!
dvb_usb_m920x: probe of 5-1:1.0 failed with error 64
usb 5-1: USB disconnect, address 4
usb 5-1: new high speed USB device using ehci_hcd and address 5
usb 5-1: configuration #1 chosen from 1 choice
Probing for m920x device at interface 0
dvb-usb: found a 'Dposh(mt2060 tuner) DVB-T USB2.0' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (Dposh(mt2060 tuner) DVB-T USB2.0)
m920x_mt352_frontend_attach
DVB: registering frontend 0 (Zarlink MT352 DVB-T)...
m920x_mt2060_tuner_attach
MT2060: successfully identified (IF1 = 1220)
dvb-usb: Dposh(mt2060 tuner) DVB-T USB2.0 successfully initialized and connected.

so far so good :) , but when I scan with Kaffeine I get this:

Demod init!    //this repeated ~ 30 times

mt352_read_register: readreg error (reg=3, ret==-110)  //then this block or
mt2060 I2C write failed (len=2)                           //similar repeated until end of scan
mt2060 I2C write failed (len=6)
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt2060 I2C read failed
mt352_write() to reg 51 failed (err = -110)!
mt352_write() to reg 5e failed (err = -110)!


Could this just be due to not getting the .i2c_address set in the 'm920x_mt2060_config' struct correct, or is it another dumb error on my part?
cheers for the help,
Andrew

_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb