Yes I have the same card as you John Vendor ID: 0x14f1 Device ID: 0x8800 Subsystem ID: 0xdb1018ac Please let me know your alsa setting I have tried everything :( -----Original Message----- From: linux-dvb-bounces@xxxxxxxxxxx [mailto:linux-dvb-bounces@xxxxxxxxxxx] On Behalf Of Anthony Giggins Sent: Saturday, 5 May 2007 11:35 PM To: linux-dvb@xxxxxxxxxxx Subject: RE: Divco Fusion HDTV DVB-T PlusNoAudio for composite/s-video input The card I have is subsystem: 18ac:db10 not sure where your getting the 14f1:8802 from. Can you please tell me how you have configured your alsa I have tried connecting the supplied cable too both the AUX and the CDROM inputs on the SBlive sound card I am using. I'll hopefully be attempting the regspy GPIO stuff tomorrow if all goes too plan. Thanks for the idea, keep them coming :) -----Original Message----- From: linux-dvb-bounces@xxxxxxxxxxx [mailto:linux-dvb-bounces@xxxxxxxxxxx] On Behalf Of John Newbigin Sent: Saturday, 5 May 2007 4:47 PM To: linux-dvb@xxxxxxxxxxx Subject: Re: Divco Fusion HDTV DVB-T Plus NoAudio for composite/s-video input Is this the 14f1:8802 Subsystem: 18ac:db10 If so, I have the same card. It does not support audio capture. You must you the supplied cable to connect to you sound card aux/line in. You then must configure alsa correctly to allow recording from the input you are using (test with arecord | aplay) I also found the analog capture on this card is rubbish and I would recommend people avoid it. The digital works fine. John. Michael Krufky wrote: > Anthony Giggins wrote: > >> Hello Everyone, >> >> I am using this card with Mythtv under mythdora distro (www.mythdora.com) >> for DVB with minimal problems but I am unable too get any audio via >> composite/s-video input, video works fine. >> This is pretty much my last remaining problem, I've searched every mailing >> list I can think of and have several other people in the same boat in >> varying distro's can anyone give me anything I can try, the passthrough >> audio cable is plugged into my SB Live value card and I believe I have >> alsa configured correctly but I could be wrong. >> >> Please Help! >> > > We may need to program the GPIO for those input muxes... Please see the GPIO pins section, cx2388x subsection of the v4lwiki, located at http://linuxtv.org/v4lwiki ... You'll need to use regspy, which is part of the dscaler project, in conjunction with the DViCO windows drivers and FusionHDTV application, in order to sniff the GPIO settings of the windows driver. With that data, we should be able to resolve this problem for you. > > I am looking at the current code, which sets gpio0 to 0x000027df ... Perhaps this is inaccurate, or you have an alternate revision of this model. Let me know what you find from regspy. > > Good Luck, > > Mike Krufky > > _______________________________________________ > linux-dvb mailing list > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
