On 1/17/2024 6:56 AM, Andrew Lunn wrote:
Another one is the MDIO slave(gpio25, 26), which is dedicated
for receiving the back pressure signal from the connected Ethernet switch
device QCA8386.
There is a MDIO master block integrated in QCA8386 switch device, this
integrated MDIO master is dedicated for generating the back
pressure signal to IPQ5332 SoC.
This MDIO slave block of IPQ5322 just needs to configure these PIN
mux for MDC and MDIO PINs. No additional driver is needed for this MDIO
slave block of IPQ5332.
So there is a proprietary protocol running over the MDIO bus? And its
completely implemented in hardware in the slave block? Is this even
MDIO? Does it use c22 or c45 bus transactions? How is the slave
address configured, or is that also hard coded?
Andrew
Hi Andrew,
Yes, this is a custom HW mechanism using the MDIO C22 frame, to enable
back pressure from the QCA8386 switch to the IPQ5332 SoC. The slave
block in the IPQ5332 SoC implements the back pressure function. There is
no configuration for the MDIO slave address of IPQ5332 required, since
the connection is one to one between slave and master.
However upon further review, we believe this node definition belongs to
the board DTS file, since the switch configuration is a board property.
We will move out this MDIO slave config from the patch series to
avoid the confusion. We will also rename the node from 'mdio0-state' to
'backpressure-state' to make this clear.
Thanks.
