On 1/2/06, Oliver Endriss <o.endriss@xxxxxx> wrote: > > Paul Lacatus wrote: > > I am using vdr 1.3.37 on full featured thechnisat Rev 1.3 card. Drivers > are > > from kernel 2.6.14. I have another digital receiver connected on the > loop > > output of the ss1 board. After closing vdr by ctrl-c in console the > ss1 > > in not powering anymore the LNB leaving the other receiver to do that > but > > is not allowing the high frequency signal to pass trough (I presume ) > since > > the other receiver is indicating bad signal. If I restart the computer > all > > is ok until I start again vdr. I don't know if the problem is from vdr > or > > drivers. > > Load the dvb-core module with parameter 'dvb_shutdown_timeout=0'. Thanks Oliver but i gave up of connecting another receiver on loop since I need to leave my vdr powered up when using the other receiver. I am using now a very simple relay switch . Regards Paul -- > -------------------------------------------------------- > VDR Remote Plugin available at > http://www.escape-edv.de/endriss/vdr/ > -------------------------------------------------------- > > _______________________________________________ > vdr mailing list > vdr@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr > -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.linuxtv.org/pipermail/vdr/attachments/20060102/31567538/attachment.htm
