I am using vdr 1.3.37 on full featured thechnisat Rev 1.3 card. Drivers are from kernel 2.6.14. I have another digital receiver connected on the loop output of the ss1 board. After closing vdr by ctrl-c in console the ss1 in not powering anymore the LNB leaving the other receiver to do that but is not allowing the high frequency signal to pass trough (I presume ) since the other receiver is indicating bad signal. If I restart the computer all is ok until I start again vdr. I don't know if the problem is from vdr or drivers. -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.linuxtv.org/pipermail/vdr/attachments/20060101/d33df5f2/attachment.htm
