Sorry for the late reply. I just tried this with pjsip SVN version and couldn't reproduce the problem. Could you post a snippet perhaps? Also may be better to try the SVN version instead. cheers, -benny jorge.amador at withus.pt wrote: > Hi Benny, > > I changed to the 0.7.0 version and succeded adding udp transport on > both eth devices. However when I try to lock one account to one > transport and another account to another transport (each transport > with different IP addresses and ports) it doesn't work. Both accounts > get locked to the same transport and it is always the last transport > that I configure. I'm using pjsua_acc_set_transport() with the account > id that I want to lock to a transport id. Any idea of what is going > wrong? Thanks a lot for your help. > > Best regards, > > Jorge Amador > > Quoting Benny Prijono <bennylp at pjsip.org>: > >> jorge.amador at withus.pt wrote: >>> Hi everyone, >>> >>> I'm using pjsip 0.5.10.4 in an equipment that as three Ethernet >>> devices each one with a IP address. I want to create 2 accounts for >>> Eth1, 2 accounts for Eth2 and none for Eth0, using the same PJSUA. Is >>> it possible? >> Not with 0.5.10.x, and maybe with 0.7 version (or probably the SVN >> version). In 0.7.x, there is an API to "lock" account to specific >> transport, with pjsua_acc_set_transport(). And since you can bind >> transport to a specific interface, effectively you can control which >> interface should be used by an account. >> >> cheers, >> -benny >> >>> Thanks everyone, >>> >>> Jorge Amador
