Hi Sourav, On 10/11/2012 05:21 AM, Sourav wrote: [snip] > I already enable software flow control and did the testing on beagle, > where things are working fine > after off mode. > But if I enable hardware flow control, the teraterm does not allow me to > load my fs and uImage from mmc. > If you have any pointers on how to test hardware flow control, I will > like to do that on my beagle board. For h/w flow control, you need to check if the CTS and RTS signals are being brought out to the serial header on the beagle-board. Looking at the schematics for the 3430 beagle board, it appears that only the UART RX and TX signals are available on the serial header. Therefore, I don't believe you can test h/w flow control using the console with that board. I do see that you can access all the UART2 signals (RX/TX/CTS/RTS) via the expansion connector on the beagle. However, to connect to a serial port on a PC you need to have a voltage level-shifter in-between. There are some companies out there that make them [1], but you need to make sure you have one that can support a 1.8V input. Cheers Jon [1] http://elinux.org/RS232_Level_Shifter -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
