Re: [RFC 00/24] OMAP serial driver flow control fixes, and preparation for DMA engine conversion

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hi Kevin,
On Wednesday 10 October 2012 11:59 PM, Kevin Hilman wrote:
Hi Sourav,

Sourav <sourav.poddar@xxxxxx> writes:

[...]

Boot Tested this patch series against v3.6 tag(applied cleanly) on
panda board and
PM tested(hitting off in Idle and suspend) on omap3630 based beagle board.

Note, I also tested the patches against the current master but only
after rebasing, since the current master includes serial patches from
Felipe Balbi[1].
[1] https://lkml.org/lkml/2012/8/24/139

Tested-by: Sourav Poddar <sourav.poddar@xxxxxx>
Did you test flow control after off-mode transitons?

Russell indicated that the context save/restore is not saving important
bits related to HW flow control, so I suspect some more testing,
specifically of flow control after off-mode is needed.

Kevin
The testing done was without any flow control enabled.
I will try to figure out how to do a hardware flow control testing
and see the status after the off mode.

~Sourav

--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Arm (vger)]     [ARM Kernel]     [ARM MSM]     [Linux Tegra]     [Linux WPAN Networking]     [Linux Wireless Networking]     [Maemo Users]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux