On Thu, Oct 11, 2012 at 03:13:43PM +0530, Sourav wrote: > > Hi Kevin, > On Wednesday 10 October 2012 11:59 PM, Kevin Hilman wrote: >> Hi Sourav, >> >> Sourav <sourav.poddar@xxxxxx> writes: >> >> [...] >> >>> Boot Tested this patch series against v3.6 tag(applied cleanly) on >>> panda board and >>> PM tested(hitting off in Idle and suspend) on omap3630 based beagle board. >>> >>> Note, I also tested the patches against the current master but only >>> after rebasing, since the current master includes serial patches from >>> Felipe Balbi[1]. >>> [1] https://lkml.org/lkml/2012/8/24/139 >>> >>> Tested-by: Sourav Poddar <sourav.poddar@xxxxxx> >> Did you test flow control after off-mode transitons? >> >> Russell indicated that the context save/restore is not saving important >> bits related to HW flow control, so I suspect some more testing, >> specifically of flow control after off-mode is needed. >> >> Kevin > The testing done was without any flow control enabled. So, as the patch set is about fixing the flow control stuff, would you say that your testing without flow control enabled has much value? > I will try to figure out how to do a hardware flow control testing > and see the status after the off mode. It's software flow control which isn't properly restored... -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
