On 12/08/2012 10:20 AM, Frank Schäfer wrote:
Am 08.12.2012 15:10, schrieb Matthew Gyurgyik:
Ok, thanks. So the USB log was right and the bridge setup should be
complete, except that the remote control doesn't work yet...
Could you please test the patch in the attachment ?
Changes from V3:
- use the correct demodulator configuration
- changed the remote control map to RC_MAP_KWORLD_315U (same as DIGIVOX
III but without NEC extended address byte)
- switched from the KWorld std_map for the tuner to a custom one. For
QAM, I selected the values from the log and for atsc I took the standard
values from the tda18271 driver.
Regards,
Frank
I tested the patch and this is what I found
The remote still doesn't work, would it be helpful to do a usb snoop
while using the remote in windows (not sure I can make the win7 driver
work in xp)?
http://pyther.net/a/digivox_atsc/patch4/evtest.txt
A channel scan still fails with the following error:
> start_filter:1752: ERROR: ioctl DMX_SET_FILTER failed: 71 Protocol error
However there are no messages in dmesg that indicate any errors / warnings.
http://pyther.net/a/digivox_atsc/patch4/scan.txt
When using mplayer dvb://
It seems that switching channels work a bit better, I can switch more
channels before I get errors and mplayer closes.
http://pyther.net/a/digivox_atsc/patch4/mplayer.txt
Dmesg: http://pyther.net/a/digivox_atsc/patch4/dmesg.txt
Thanks,
Matthew
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
