On Tue, 4 Sep 2018 17:13:14 +0300 Stefan Popa <stefan.popa@xxxxxxxxxx> wrote: > The adxl372 is designed to communicate in either SPI or I2C protocol. > This patch adds the documentation of device tree bindings for adxl372 > I2C. > > Signed-off-by: Stefan Popa <stefan.popa@xxxxxxxxxx> Applied. Thanks, Jonathan > --- > Documentation/devicetree/bindings/iio/accel/adxl372.txt | 15 +++++++++++++-- > 1 file changed, 13 insertions(+), 2 deletions(-) > > diff --git a/Documentation/devicetree/bindings/iio/accel/adxl372.txt b/Documentation/devicetree/bindings/iio/accel/adxl372.txt > index 9409984..a289964 100644 > --- a/Documentation/devicetree/bindings/iio/accel/adxl372.txt > +++ b/Documentation/devicetree/bindings/iio/accel/adxl372.txt > @@ -4,14 +4,25 @@ http://www.analog.com/media/en/technical-documentation/data-sheets/adxl372.pdf > > Required properties: > - compatible : should be "adi,adxl372" > - - reg: SPI chip select number for the device > + - reg: the I2C address or SPI chip select number for the device > + > +Required properties for SPI bus usage: > - spi-max-frequency: Max SPI frequency to use > > Optional properties: > - interrupts: interrupt mapping for IRQ as documented in > Documentation/devicetree/bindings/interrupt-controller/interrupts.txt > > -Example: > +Example for a I2C device node: > + > + accelerometer@53 { > + compatible = "adi,adxl372"; > + reg = <0x53>; > + interrupt-parent = <&gpio>; > + interrupts = <25 IRQ_TYPE_EDGE_FALLING>; > + }; > + > +Example for a SPI device node: > > accelerometer@0 { > compatible = "adi,adxl372";
