On Fri, Jul 12, 2002 at 11:31:58PM -0400, Buro, Nicholas F wrote: > > Yes, it does seem to work without issues, so I will probably end up using it > on the kickstart disk, and then possibly use the tg3 driver. Just drop something into %post like: perl -pi -e 's/bcm5700/tg3/g' /etc/modules.conf > Is the driver located on broadcom's site? I can't seem to find the 2.2.27 > version you mentioned. That would be very helpful to check out, I wasn't > aware that there was active development on the broadcom one. Nope... apparently they (Broadcom) don't distribute any drivers and rely on their OEMs to handle it (ie, Dell, Compaq, whoever). You might want to try looking through the source to see if there's a developer's email addy you can try. Side note: just tried a kickstart of 7.3 with the 2.2.27 bcm5700 driver, and for some reason the card can't set up a defaultroute... so maybe that's not the best route to be going down. :-) -- Kelley Spoon Main: 210-892-4000 Rackspace Managed Hosting Fax: 210-892-4329 112 East Pecan, Suite 600 Email: kspoon@xxxxxxxxxxxxx San Antonio, TX 78205 <http://www.rackspace.com>
