Wolf Blecher wrote: > > Hi, > > I encountered a strange problem with my Geforce 2 Card. > I tried to configure it, but it doesn't seem to work, so i switched > my Flat-Screen to the analogous port, and started to configure again. > So here it works, I selected the Vesa-Mode (with is supported by my > Philips Brilliance 150P by manual) 1024x768@60Hz and it looks pretty > good. > The I rebooted my Computer (AMD Athlon 900, Asus V7100/2V1D for > Graphics) and switched back to the Digital Output. As long, as I work > on the console, everything looks fine, but when I type startx, my > screen blanks, and sends itself into Sleep, because it doesn't > receive any signal. > I'm using the nv-Driver shipped with XFree 4.2.0 on a FreeBSD 4.6 > System. The log-file doesn't show any Errors. Hi, in the meantime I've setup a 14,1" (XGA) DVI driven TFT, as I mentoined before Dot-Clock is important. I figured out following modelines for this system: Modeline "1024x768" 61.19 1024 1040 1216 1328 768 768 775 802 These modelines are used with Matrox G550 and standard driver supplied with Suse 8.0 (Xfree86 4.2). Horizontal Sync is set to 24-60 (khz) , vertical to 50-60 (hz) Maybe you have to modify the Dot-Clock. As I know 15" Panel are using 2 pix/ Clock to minimize EMI, so you've divide DC ,as mentoined from Manual by 2 . rgds Detlef _______________________________________________ Newbie@XFree86.Org *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
