> I encountered a strange problem with my Geforce 2 Card. > I tried to configure it, but it doesn't seem to work, so i switched > my Flat-Screen to the analogous port, and started to configure again. > So here it works, I selected the Vesa-Mode (with is supported by my > Philips Brilliance 150P by manual) 1024x768@60Hz and it looks pretty > good. > The I rebooted my Computer (AMD Athlon 900, Asus V7100/2V1D for > Graphics) and switched back to the Digital Output. As long, as I work > on the console, everything looks fine, but when I type startx, my > screen blanks, and sends itself into Sleep, because it doesn't > receive any signal. > I'm using the nv-Driver shipped with XFree 4.2.0 on a FreeBSD 4.6 > System. The log-file doesn't show any Errors. Hallo, I'm not sure, for me it looks that modelines including correct Dot-Clock is very important, to fire on an LCD on the DVI Port. Nvidia is offering Linux Driver for a wide range of their Graphic Chips, but I don't know if these drivers are usefull for BSD. Even if it's not helpfull yet, currently I've 18,1" TFT running on DVI. regards Detlef _______________________________________________ Newbie@XFree86.Org *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
