Is their a list of drivers with their corresponding MTU size required.
Some of the old 10/110 as well as gig cards.
Thanks
Gary
Ard van Breemen wrote:
Hi,
On Fri, Jun 29, 2007 at 05:19:06PM +0100, Gary Smith wrote:
I have been running a VLAN configured system for some years using 10/100
Sundance driver cards without a problem. I recently tried on a HP
proliant server using gigabit cards and found a problem related to the
MTU size for the interface I an using.
The 10/100 cards seem to need a MTU of 1504 bytes, but this size does
not work with the e1000 gig cards, or the US robotics, Dlink DGE,
broadcom etc. I have to move the MTU down to 1500 to make fragmentation
work and allow it to pass the larger packets.
>From what I read, I guesss the vlan on sundance is software only,
and need a special MTU of 1504.
Most gigabit cards (not all!) already strip the vlan tag, so the
driver only sees a payload of 1500 and somewhere else in the
receiver buffer the vlan tag is found.
Is this what I should expect from the e1000, broadcom, R8169 drivers for
gigabit cards?
I've been using vlans since 2.4.14 or so, and I have never had to
set the MTU size to 1504 for any of my cards. I do know however
that some of the drivers need the MTU size of 1504 to keep it
from discarding it as a long packet and to cope for the increased
buffer size needed.
_______________________________________________
Vlan mailing list
Vlan@xxxxxxxxxxxxxxx
http://www.candelatech.com/mailman/listinfo/vlan
|
_______________________________________________
Vlan mailing list
Vlan@xxxxxxxxxxxxxxx
http://www.candelatech.com/mailman/listinfo/vlan
