He has a Dish Pro LNB. The switching is done via the two LO settings. He wants V high always for propper operration of the LNB. They like the voltage to be at 18-19v Try increasing the delay a tad. change the W15's to W20 and the first W20's to W25's. The W20's at the end I don't think are needed. ----- Original Message ----- From: "Thiemo" <rollercoaster@xxxxxxxxxxxxxxxxxxx> To: "VDR Mailing List" <vdr@xxxxxxxxxxx> Sent: Friday, November 09, 2007 3:07 AM Subject: Re: VDR doesn't always switch channel correctly > Am Donnerstag 08 November 2007 schrieb Maxime Laplante: > > Hi guys, > > > > I'm running VDR 1.4.0 on my CaptiveWorks CW-3000HD FTA receiver. > > > > My current diseqc.conf is: > > > > # DiseqC Configuration > > > > # Port 0 Galaxy 11 & Nimiq 1,3 > > S91.0W 99999 V 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > > S91.0W 99999 H 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > > S91.0W 99999 R 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > > S91.0W 99999 L 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > > I dont see how switching the polarisation is done - as toneburst, voltage and > diseqc commands are all the same for each polarisation. > Also a repeated command should start with "E1" because "E0" would be for the > next (cascaded) switch which is most probably not what was intended... > You could also repeat the commands twice, which is the default. > A correct diseqc block with 2 repeats should look like this: > > S19.2E 11700 V 9750 t v W15 [E0 10 38 F0] W15 [E1 10 38 F0] W15 [E1 10 38 > F0] W15 t > S19.2E 99999 V 10600 t v W15 [E0 10 38 F1] W15 [E1 10 38 F1] W15 [E1 10 38 > F1] W15 T > S19.2E 11700 H 9750 t V W15 [E0 10 38 F2] W15 [E1 10 38 F2] W15 [E1 10 38 > F2] W15 t > S19.2E 99999 H 10600 t V W15 [E0 10 38 F3] W15 [E1 10 38 F3] W15 [E1 10 38 > F3] W15 T > > regards, > T. > > _______________________________________________ > vdr mailing list > vdr@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr