Am Donnerstag 08 November 2007 schrieb Maxime Laplante: > Hi guys, > > I'm running VDR 1.4.0 on my CaptiveWorks CW-3000HD FTA receiver. > > My current diseqc.conf is: > > # DiseqC Configuration > > # Port 0 Galaxy 11 & Nimiq 1,3 > S91.0W 99999 V 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > S91.0W 99999 H 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > S91.0W 99999 R 11250 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 > S91.0W 99999 L 14350 t V W15 [E0 10 38 F2] W20 [E0 10 38 F2] W20 I dont see how switching the polarisation is done - as toneburst, voltage and diseqc commands are all the same for each polarisation. Also a repeated command should start with "E1" because "E0" would be for the next (cascaded) switch which is most probably not what was intended... You could also repeat the commands twice, which is the default. A correct diseqc block with 2 repeats should look like this: S19.2E 11700 V 9750 t v W15 [E0 10 38 F0] W15 [E1 10 38 F0] W15 [E1 10 38 F0] W15 t S19.2E 99999 V 10600 t v W15 [E0 10 38 F1] W15 [E1 10 38 F1] W15 [E1 10 38 F1] W15 T S19.2E 11700 H 9750 t V W15 [E0 10 38 F2] W15 [E1 10 38 F2] W15 [E1 10 38 F2] W15 t S19.2E 99999 H 10600 t V W15 [E0 10 38 F3] W15 [E1 10 38 F3] W15 [E1 10 38 F3] W15 T regards, T. _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
