Hi, On Thu, Feb 15, Dieter Bloms wrote: > no diseqc setup works stabel for me :( > Also the Full DiSEqC sequence from default diseqc.conf doesn't work > a few hours after reboot and sometime it doesn't work directly after > reboot. > But I can switch the channel with szap and get the TS stream from > /dev/dvb/adapter1/dvr0 every time, even vdr can't record I only stop vdr > and do not a reload of the driver. > > I did some tests with szap: > > o I can only get the TS stream with the default lnb type or -l UNIVERSAL > o if I use another lnb type like ENHANCED, I can switch, but don't get > any data. > o The ioctls are the same if I use diseqc with vdr, but as I said > before, I didn't get any data a few hours after reboot of the system, > and sometime I didn't get any data directly after reboot. > o If I use szap, I can switch the channels and get the ts stream every > time (via cat /dev/dvb/adapter1/dvr0 > /tmp/bla). > o the first status is 01 and it has no lock all others are 1f and it has > a lock (as seen below). > o when I call szap the second time (with the same channel) the first > status is 01 and then 1f, too. > o maybe vdr does have to wait a longer time ? I can reproduce following: vdr can record from senders on V polarisation like sat1, prosieben ... even without reloading the driver. vdr can not record from any sender on H polarisation like ard, zdf ... even with reloading the driver it doesn't work. This explains, that I got some recording and some not. Does anybody know what can be the different between H and V polarisation ? -- Gru? Dieter -- I do not get viruses because I do not use MS software. If you use Outlook then please do not put my email address in your address-book so that WHEN you get a virus it won't use my address in the
