Hi, On Sat, Feb 10, Reinhard Nissl wrote: > > Feb 9 12:02:00 video vdr: [30529] switching device 2 to channel 1 > > Feb 9 12:02:09 video vdr: [30537] frontend 1 timed out while tuning to channel 1, tp 111836 > > Feb 9 12:02:32 video vdr: [30603] ERROR: video data stream broken > > > > so why can I get ts streams from the second dvb card and vdr doesn't get > > any bytes ? > > As you can see from the above lines, tuning fails for device 2 (= > frontend 1) as VDR reports a timeout about 10 seconds after switching to > this channel. VDR retries tuning in that case, but further reports are > suppressed for the next 60 seconds so you don't see a second timeout report. > > Finally, after 30 seconds, the recording thread issues an emergency exit > as it didn't see any data (=> video data stream broken) as the device > was not able to tune to the channel. > > Is your DiSEqC setup correct (in case you are using DiSEqC)? I don't have a diseqc setup, I have a twin lnb and both dvb cards are connected directly. It worked in the past, ok many timeouts, but after reloading the driver and restart of vdr it worked. I was amazed that vdr can not tune to a channel and szap can do it without reloading the driver ! Maybe they use differnt methods to switch the channels. -- Gru? Dieter -- I do not get viruses because I do not use MS software. If you use Outlook then please do not put my email address in your address-book so that WHEN you get a virus it won't use my address in the
