Hi,
On Sun, Jun 22, 2014 at 11:50:56PM +0200, Sebastian Hesselbarth wrote:
> On 06/22/2014 10:34 PM, Alexander Aring wrote:
> > This patch add a basic support for the D-Link DNS-325.
> >
> > Currently only booting via uart with kwboot is supported. The barebox
> > kwboot utility doesn't work at the moment. Use kwboot utility from u-boot
> > instead.
>
> Why does kwboot does not work? There is an issue with early Kirkwood's
> BootROM and UART boot mode. Just try over and over again. I also recall
> modifying the timeouts may help.
>
I tried to change the timeouts and it works now. I take these timings from
u-boot. Is there any reason why these timings differs?
Datasheet says nothing about any delay while loop for sending bootmsg.
Here is my diff with the very small change:
diff --git a/scripts/kwboot.c b/scripts/kwboot.c
index e068660..bcb5972 100644
--- a/scripts/kwboot.c
+++ b/scripts/kwboot.c
@@ -34,8 +34,8 @@ static unsigned char kwboot_msg_debug[] = {
0xDD, 0x11, 0x22, 0x33, 0x44, 0x55, 0x66, 0x77
};
-#define KWBOOT_MSG_REQ_DELAY 1000 /* ms */
-#define KWBOOT_MSG_RSP_TIMEO 1000 /* ms */
+#define KWBOOT_MSG_REQ_DELAY 10 /* ms */
+#define KWBOOT_MSG_RSP_TIMEO 50 /* ms */
/*
* Xmodem Transfers
btw.:
Now I see that the internal ROM bootloader could also boot from SATA
device - this sounds interesting. I will try that next weekend.
Thanks for your great help Sebastian!
- Alex
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
