The cd burning problems from phoebe are still there in 9, for me at least. I managed to get 5 good burns and 10 coasters yesterday. I was getting an every-other-try rate, then I got about 4 coasters in a row. Every burn attempt, successful or otherwise results in a "power on, reset, or bus device reset occurred" message during the fixate process. Unsuccessful burns follow this up with an "incompatible medium" message. The output from cdrecord for a successful burn followed by a failure is below. I had no problems under 8.0 with this system. The issue is further compounded by the fact that, though I've only been able to do a couple of burns with a CD-RW, my home system hasn't had any problems so far (not even the "bus device reset" message). I've killed and removed magicdev, and turned DMA on/off. Nothing seems to make a difference. My system: K6-2 450, VIA MVP-4 chipset with integrated video/audio, 384MB RAM, Sony CRX120E burner (4x8x2x). Anyone with similar issues or suggestions before I bugzilla this? GnomeToaster Recording Terminal Recording 51937280 bytes to CD GnomeToaster is calling the following command: cdrecord dev=0,0,0 speed=4 -data tsize=51937280 /tmp/gtoaster Cdrecord 2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jrg Schilling Using libscg version 'schily-0.7' Device type : Removable CD-ROM Version : 0 Response Format: 1 Vendor_info : 'SONY ' Identifikation : 'CD-RW CRX120E ' Revision : '1.0j' Device seems to be: Generic mmc CD-RW. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : MMC SWABAUDIO Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R Starting to write CD/DVD at speed 4 in real TAO mode for single session. Last chance to quit, starting real write in 9 seconds. 8 seconds. 7 seconds. 6 seconds. 5 seconds. 4 seconds. 3 seconds. 2 seconds. 1 seconds. 0 seconds. Operation starts.scsidev: '0,0,0' scsibus: 0 target: 0 lun: 0 Linux sg driver version: 3.1.24 cdrecord: Warning: using inofficial libscg transport code version (schily - Red Hat-scsi-linux-sg.c-1.75-RH '@(#)scsi-linux-sg.c 1.75 02/10/21 Copyright 1997 J. Schilling'). fixating CDROM. Track 01: Total bytes read/written: 51937280/51937280 (25360 sectors). cdrecord: Input/output error. close track/session: scsi sendcmd: no error CDB: 5B 00 02 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 06 00 00 00 00 12 00 00 00 00 29 00 00 00 Sense Key: 0x6 Unit Attention, Segment 0 Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 64.976s timeout 480s cmd finished after 64.976s timeout 480s CD recording process finished. Recording 51937280 bytes to CD GnomeToaster is calling the following command: cdrecord dev=0,0,0 speed=4 -data tsize=51937280 /tmp/gtoaster Cdrecord 2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jrg Schilling Using libscg version 'schily-0.7' Device type : Removable CD-ROM Version : 0 Response Format: 1 Vendor_info : 'SONY ' Identifikation : 'CD-RW CRX120E ' Revision : '1.0j' Device seems to be: Generic mmc CD-RW. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : MMC SWABAUDIO Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R Starting to write CD/DVD at speed 4 in real TAO mode for single session. Last chance to quit, starting real write in 9 seconds. 8 seconds. 7 seconds. 6 seconds. 5 seconds. 4 seconds. 3 seconds. 2 seconds. 1 seconds. 0 seconds. Operation starts.scsidev: '0,0,0' scsibus: 0 target: 0 lun: 0 Linux sg driver version: 3.1.24 cdrecord: Warning: using inofficial libscg transport code version (schily - Red Hat-scsi-linux-sg.c-1.75-RH '@(#)scsi-linux-sg.c 1.75 02/10/21 Copyright 1997 J. Schilling'). fixating CDROM. Track 01: Total bytes read/written: 51937280/51937280 (25360 sectors). cdrecord: Input/output error. close track/session: scsi sendcmd: no error CDB: 5B 00 02 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 06 00 00 00 00 12 00 00 00 00 29 00 00 00 Sense Key: 0x6 Unit Attention, Segment 0 Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 25.137s timeout 480s cmd finished after 25.137s timeout 480s cdrecord: Input/output error. test unit ready: scsi sendcmd: no error CDB: 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 02 00 00 00 00 12 00 00 00 00 30 00 00 00 Sense Key: 0x2 Not Ready, Segment 0 Sense Code: 0x30 Qual 0x00 (incompatible medium installed) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 0.656s timeout 40s CD recording process finished. -- Michael Knepher <limbo@xxxxxxxxxxxxxx>
