I don't get all of the errors you are getting, but so far, I have produced a rather large stack of coasters which were formerly known as CDs as well! Nothing I do seems to help. My system is: 2.53Ghz P4 1GB RAM Memorex 52X EIDE CD-RW Sony DVD-ROM Stock Red Hat 9 with all of the up2date fixes as of today. Cheers, Chris On Fri, 2003-04-04 at 10:19, Michael Knepher wrote: > The cd burning problems from phoebe are still there in 9, for me at > least. I managed to get 5 good burns and 10 coasters yesterday. I was > getting an every-other-try rate, then I got about 4 coasters in a row. > Every burn attempt, successful or otherwise results in a "power on, > reset, or bus device reset occurred" message during the fixate process. > Unsuccessful burns follow this up with an "incompatible medium" message. > The output from cdrecord for a successful burn followed by a failure is > below. > > I had no problems under 8.0 with this system. The issue is further > compounded by the fact that, though I've only been able to do a couple > of burns with a CD-RW, my home system hasn't had any problems so far > (not even the "bus device reset" message). > > I've killed and removed magicdev, and turned DMA on/off. Nothing seems > to make a difference. > > My system: K6-2 450, VIA MVP-4 chipset with integrated video/audio, > 384MB RAM, Sony CRX120E burner (4x8x2x). > > Anyone with similar issues or suggestions before I bugzilla this? > > GnomeToaster Recording Terminal > Recording 51937280 bytes to CD > GnomeToaster is calling the following command: > cdrecord dev=0,0,0 speed=4 -data tsize=51937280 /tmp/gtoaster > Cdrecord 2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jrg Schilling > Using libscg version 'schily-0.7' > Device type : Removable CD-ROM > Version : 0 > Response Format: 1 > Vendor_info : 'SONY ' > Identifikation : 'CD-RW CRX120E ' > Revision : '1.0j' > Device seems to be: Generic mmc CD-RW. > Using generic SCSI-3/mmc CD-R driver (mmc_cdr). > Driver flags : MMC SWABAUDIO > Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R > Starting to write CD/DVD at speed 4 in real TAO mode for single session. > Last chance to quit, starting real write in 9 seconds. 8 > seconds. 7 seconds. 6 > seconds. 5 seconds. 4 > seconds. 3 seconds. 2 > seconds. 1 seconds. 0 seconds. Operation > starts.scsidev: '0,0,0' > scsibus: 0 target: 0 lun: 0 > Linux sg driver version: 3.1.24 > cdrecord: Warning: using inofficial libscg transport code version > (schily - Red Hat-scsi-linux-sg.c-1.75-RH '@(#)scsi-linux-sg.c 1.75 > 02/10/21 Copyright 1997 J. Schilling'). > > fixating CDROM. > > Track 01: Total bytes read/written: 51937280/51937280 (25360 sectors). > cdrecord: Input/output error. close track/session: scsi sendcmd: no > error > CDB: 5B 00 02 00 00 00 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 06 00 00 00 00 12 00 00 00 00 29 00 00 00 > Sense Key: 0x6 Unit Attention, Segment 0 > Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset > occurred) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 64.976s timeout 480s > cmd finished after 64.976s timeout 480s > CD recording process finished. > Recording 51937280 bytes to CD > GnomeToaster is calling the following command: > cdrecord dev=0,0,0 speed=4 -data tsize=51937280 /tmp/gtoaster > Cdrecord 2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jrg Schilling > Using libscg version 'schily-0.7' > Device type : Removable CD-ROM > Version : 0 > Response Format: 1 > Vendor_info : 'SONY ' > Identifikation : 'CD-RW CRX120E ' > Revision : '1.0j' > Device seems to be: Generic mmc CD-RW. > Using generic SCSI-3/mmc CD-R driver (mmc_cdr). > Driver flags : MMC SWABAUDIO > Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R > Starting to write CD/DVD at speed 4 in real TAO mode for single session. > Last chance to quit, starting real write in 9 seconds. 8 > seconds. 7 seconds. 6 > seconds. 5 seconds. 4 > seconds. 3 seconds. 2 > seconds. 1 seconds. 0 seconds. Operation > starts.scsidev: '0,0,0' > scsibus: 0 target: 0 lun: 0 > Linux sg driver version: 3.1.24 > cdrecord: Warning: using inofficial libscg transport code version > (schily - Red Hat-scsi-linux-sg.c-1.75-RH '@(#)scsi-linux-sg.c 1.75 > 02/10/21 Copyright 1997 J. Schilling'). > > fixating CDROM. > > Track 01: Total bytes read/written: 51937280/51937280 (25360 sectors). > cdrecord: Input/output error. close track/session: scsi sendcmd: no > error > CDB: 5B 00 02 00 00 00 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 06 00 00 00 00 12 00 00 00 00 29 00 00 00 > Sense Key: 0x6 Unit Attention, Segment 0 > Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset > occurred) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 25.137s timeout 480s > cmd finished after 25.137s timeout 480s > cdrecord: Input/output error. test unit ready: scsi sendcmd: no error > CDB: 00 00 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 02 00 00 00 00 12 00 00 00 00 30 00 00 00 > Sense Key: 0x2 Not Ready, Segment 0 > Sense Code: 0x30 Qual 0x00 (incompatible medium installed) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 0.656s timeout 40s > CD recording process finished. > > -- > Michael Knepher <limbo@xxxxxxxxxxxxxx> -- ==================================== "If you get to thinkin' you're a person of some influence, try orderin' someone else's dog around." --Cowboy Wisdom
