Hi All, I am trying to get an adaptec 1210 serial ata raid controller working under 2.6.0. I've also tried 2.4.23 I've found a patch for 2.6.0 by Mark Haverkamp at http://marc.theaimsgroup.com/?l=linux-scsi&m=10663501617378&w=2 and also a patch (for 2.4.22) by someone else (not sure who) which just resulted in lots of "lost interrupt" errors at bootup and it took around 30 minutes to boot. Below is a lcpci -vvv in case this helps in identifying this card 00:0d.0 RAID bus controller: CMD Technology Inc: Unknown device 0240 (rev 02) (prog-if 01) Subsystem: Adaptec: Unknown device 0240 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32, cache line size 08 Interrupt: pin A routed to IRQ 11 Region 0: I/O ports at 9800 [size=8] Region 1: I/O ports at 9400 [size=4] Region 2: I/O ports at 9000 [size=8] Region 3: I/O ports at 8800 [size=4] Region 4: I/O ports at 8400 [size=16] Region 5: Memory at eb800000 (32-bit, non-prefetchable) [size=512] Expansion ROM at <unassigned> [disabled] [size=512K] Capabilities: [60] Power Management version 2 Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=2 PME- Does anyone have a working patch for this card? It appears as a CMD card according to the BIOS. I did manage to get it working in 2.4.23 with a "Silicon Image" driver siimage.c however it had the same problems as mentioned above, lots of "lost interrupt" and big pauses when attempting to access the disks on the controller. Any help would be great. Regards, Paul Rivoli paul@kbs.net.au K B S I N T E R N E T - To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
