Linux dpti driver in 2.4 kernel with Adaptec 2400A card

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



I'm trying to install Debian Linux with kernel 2.4.20 on a machine with an
Adaptec 2400A RAID card with 3 40Gb IDE disks attached.  The machine has
no disks other than those connected to this card. 

I am able to boot the system, and the RAID card is recognised (as
/dev/sda) but it cannot be accessed.  I get these messages recorded by
dmesg:

SCSI subsystem driver Revision: 1.00
Loading Adaptec I20 RAID: Version 2.4 Build 5
Detecting Adaptec RAID controllers...
Adaptec I20 RAID controller 0 at f8898000 size=100000 irq=11
dpti: If you have a lot of devices this could take a few minutes.
dpti0: Reading the hardware resource table.
TID 008  Vendor: HIGHPOINT    Device: IDEhpt370    Rev: 00000001
TID 009  Vendor: HIGHPOINT    Device: IDEhpt370    Rev: 00000001
TID 010  Vendor: HIGHPOINT    Device: IDEhpt370    Rev: 00000001
TID 011  Vendor: HIGHPOINT    Device: IDEhpt370    Rev: 00000001
TID 519  Vendor: ADAPTEC      Device: RAID-5       Rev: 370L
scsi0 : Vendor: Adaptec  Model: 2400A            FW:370L
  Vendor: ADAPTEC   Model: RAID-5            Rev: 370L
  Type:   Direct-Access                      ANSI SCSI revision: 02
[scsi1: Adaptec SCSI card]
[scsi2: IDE-SCSI]
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 156327936 512-byte hdwr sectors (80040 MB)
Partition check:
 sda:<4>dpti0: SCSI Data Protect-Device (0,0,0) hba_status=0x0, dev_status=0x2, cmd=0x28
dpti0: Trying to reset device
dpti0: Device reset not supported
dpti0: Bus reset: SCSI Bus 0: tid: 11
dpti0: Bus reset success.
scsi: device set offline - not ready or command retry failed after bus reset: host 0 channel 0 id 0 lun 0
SCSI disk error:  host 0 channel 0 id 0 lun 0 return code = 30002
 I/O error: dev 08:00, sector 0
 I/O error: dev 08:00, sector 2
 I/O error: dev 08:00, sector 0
 unable to read partition table

I can't find any previous references to this problem and I'm stuck. 
What can I do to get this working, please?

-- 
Oliver Elphick                                Oliver.Elphick@lfix.co.uk
Isle of Wight, UK                             http://www.lfix.co.uk/oliver
GPG: 1024D/3E1D0C1C: CA12 09E0 E8D5 8870 5839  932A 614D 4C34 3E1D 0C1C
                 ========================================
     "I love them that love me; and those that seek me early
      shall find me."                Proverbs 8:17 

-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux RAID Wiki]     [ATA RAID]     [Linux SCSI Target Infrastructure]     [Linux Block]     [Linux IDE]     [Linux SCSI]     [Linux Hams]     [Device Mapper]     [Device Mapper Cryptographics]     [Kernel]     [Linux Admin]     [Linux Net]     [GFS]     [RPM]     [git]     [Yosemite Forum]


  Powered by Linux