Hello Kishore, Following the history of "problem with MALTA thread", you had mentioned that you will try with 2.16 binutils. Have you tried with 2.16 version? Regarding 2.6.12 kernel version, it is put under stable MALTA git repository so most likely it could have been validated for MALTA platform. Regarding pci.c file of 2.6.10 version, Can you please pass me that file so I will just try directly in my 2.6.12 kernel and see if it works? Thanks and Regards, Shyamal On 4/27/06, Kishore K <hellokishore@xxxxxxxxx> wrote: > On 4/27/06, Ralf Baechle <ralf@xxxxxxxxxxxxxx> wrote: > > > > On Wed, Apr 26, 2006 at 11:12:54PM +0100, Ralf Baechle wrote: > > > > > In case you're using the default configuration file, it's set to > > > MIPS32R1 but the 4Kc is an R1 processor. Are you sure you really have > a > > > 4Kc and not a 4Kec? The latter is an R2 processor. > > > > Argh. I meant: > > > > In case you're using the default configuration file, it's set to > > MIPS32R2 but the 4Kc is an R1 processor. Are you sure you really have a > > 4Kc and not a 4Kec? The latter is an R2 processor. > > > > > > Ralf > > > I configured the kernel as required for 4Kc, but could not bring up the > board. The configuration file is enclosed along with this mail (configured > for big endian). As I mentioned in the other thread, the board comes up, > when I replace arch/mips/mips-boards/generic/pci.c file in 2.6.16 kernel > with the file from 2.6.10 with the appropriate changes required, to > pci.cfile. But, I am not sure, whether my approach is correct and what > is going > wrong with 2.6.16 kernel. Currently, I am looking into it. If any of you > have idea, please let me know. > > thanks, > --kishore > >
