On 4 November 2016 at 14:18, Mauro Mozzarelli <openwrt@xxxxxxxxxxxx> wrote: > Since the capability is implemented in software you might be testing the > limit of your router's CPU i/o speed. By loading the module in rawmode? The AP is an APU and Sta is an APU2. > > > > On 04/11/16 14:13, Bruno Antunes wrote: >> >> Hi all, >> >> Old thread but I think the issue is still present. >> >> I'm running a setup with VLANs with WDS and ath10k cards. >> >> To make it work both cards must be loaded in rawmode, AP >> and Sta, and with no security. >> >> I'm using a OpenWrt trunk r49941 and the most recent firmware, >> 10.2.4.70.58, from Kalle ath10k firmware tree. >> >> Although it works the throughput is very bad. >> Are there any alternatives to improve the throughput. >> >> Best Regards, >> Bruno >> >> On 9 December 2015 at 17:24, voncken <cedric.voncken@xxxxxxxxx> wrote: >>> >>> >>>> -----Message d'origine----- >>>> De : Ben Greear [mailto:greearb@xxxxxxxxxxxxxxx] >>>> Envoyé : mercredi 9 décembre 2015 16:34 >>>> À : Cedric VONCKEN; ath10k@xxxxxxxxxxxxxxxxxxx; linux-wireless >>>> Objet : Re: ATH10K VLAN firmware issue >>>> >>>> This only happens when you use STA + WDS, or is .1q broken for you in >>>> other cases as well? >>> >>> No, this issue occurs in all modes (STA, STA + WDS, AP). >>> >>> Thanks >>> >>> Cedric. >>> >>>> Thanks, >>>> Ben >>>> >>>> On 12/08/2015 06:29 AM, Cedric VONCKEN wrote: >>>>> >>>>> I'm testing to transmit frame with 802.1q tag (VLAN). >>>>> >>>>> My client is set in STA + WDS and the netdev is bridged with eth0. >>>>> I have a computer with vlan configuration set connected to the STA >>>>> eth0. >>>>> >>>>> If I try to transmit frames with 802.1q tag, the frames are not >>> >>> sent. >>>>> >>>>> I checked with wireless sniffer, and I don't see the frame with >>>>> VLAN >>>>> tag (the frames without VLAN tag are sent). >>>>> >>>>> I tested with firmware 10.2.4.70.14-2 from kale github, >>>>> 10.1.467-ct-com-full-015 from candelatech and 10.2.4.70-2 from >>>>> openwrt, and in all cases I have the same issue. >>>>> >>>>> Thanks for your help. >>>>> >>>>> >>>>> -- >>>>> To unsubscribe from this list: send the line "unsubscribe >>>>> linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx >>>>> More majordomo info at http://vger.kernel.org/majordomo-info.html >>>>> >>>> -- >>>> Ben Greear <greearb@xxxxxxxxxxxxxxx> >>>> Candela Technologies Inc http://www.candelatech.com >>> >>> -- >>> To unsubscribe from this list: send the line "unsubscribe linux-wireless" >>> in >>> the body of a message to majordomo@xxxxxxxxxxxxxxx >>> More majordomo info at http://vger.kernel.org/majordomo-info.html >> >> _______________________________________________ >> openwrt-devel mailing list >> openwrt-devel@xxxxxxxxxxxxxxxxx >> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel > > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@xxxxxxxxxxxxxxxxx > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
