Re: [PATCH v2 3/5] dt-bindings: usb: xhci: Add 'write-64-hi-lo-quirk' quirk

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 03/06/2024 05:34, Jung Daehwan wrote:
> On Fri, May 31, 2024 at 10:12:03AM +0200, Krzysztof Kozlowski wrote:
>> On 31/05/2024 08:07, Daehwan Jung wrote:
>>> xHCI specification 5.1 "Register Conventions" states that 64 bit
>>> registers should be written in low-high order. All writing operations
>>> in xhci is done low-high order following the spec.
>>
>> What is high-low / low-high order? Are you talking about endianness?
>>
> 
> It's not about endianness. It means 64 bit is written by 2 of 32 bit.
> It's when low-high / high-low order is needed.
> 
>>>
>>> Add a new quirk to support workaround for high-low order.
>>
>> Why? If they should be written low-high, then why breaking the spec? Why
>> this cannot be deduced from compatible?
>>
> 
> This quirk is for the controller that has a limitation in supporting
> separate ERSTBA_HI and ERSTBA_LO programming.
> 
> I've copied below from other reply to tell why this is needed.
> 
> I've found out the limitation of Synopsys dwc3 controller. This can work
> on Host mode using xHCI. A Register related to ERST should be written
> high-low order not low-high order. Registers are always written low-high order
> following xHCI spec.(64-bit written is done in each 2 of 32-bit)
> That's why new quirk is needed for workaround. This quirk is used not in
> dwc3 controller itself, but passed to xhci quirk eventually. That's because
> this issue occurs in Host mode using xHCI.
> 
>> Which *upstream* hardware is affected?
>>
> 
> dwc3 and xhci are affected.

Which upstream controllers or SoCs are affected. You did not post any
user of this.

Best regards,
Krzysztof





[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux