Re: [PATCH v2 3/5] dt-bindings: usb: xhci: Add 'write-64-hi-lo-quirk' quirk

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, May 31, 2024 at 10:12:03AM +0200, Krzysztof Kozlowski wrote:
> On 31/05/2024 08:07, Daehwan Jung wrote:
> > xHCI specification 5.1 "Register Conventions" states that 64 bit
> > registers should be written in low-high order. All writing operations
> > in xhci is done low-high order following the spec.
> 
> What is high-low / low-high order? Are you talking about endianness?
> 

It's not about endianness. It means 64 bit is written by 2 of 32 bit.
It's when low-high / high-low order is needed.

> > 
> > Add a new quirk to support workaround for high-low order.
> 
> Why? If they should be written low-high, then why breaking the spec? Why
> this cannot be deduced from compatible?
> 

This quirk is for the controller that has a limitation in supporting
separate ERSTBA_HI and ERSTBA_LO programming.

I've copied below from other reply to tell why this is needed.

I've found out the limitation of Synopsys dwc3 controller. This can work
on Host mode using xHCI. A Register related to ERST should be written
high-low order not low-high order. Registers are always written low-high order
following xHCI spec.(64-bit written is done in each 2 of 32-bit)
That's why new quirk is needed for workaround. This quirk is used not in
dwc3 controller itself, but passed to xhci quirk eventually. That's because
this issue occurs in Host mode using xHCI.

> Which *upstream* hardware is affected?
>

dwc3 and xhci are affected.

Best Regards,
Jung Daehwan

> 
> 
> Best regards,
> Krzysztof
> 
> 
> 





[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux