Igor, On my laptop, I use the APM module instead. I can shut the lid when the unit is on battery power and off it goes. Opening the lid again brings me back to where I was within just a couple of seconds. Doing this doesn't hurt system performance in any way. *********** REPLY SEPARATOR *********** On 7/19/2004 at 6:47 PM Igor Gueths wrote: >-----BEGIN PGP SIGNED MESSAGE----- >Hash: SHA1 > >Hi all. I was finally able to get Slackware-10 installed and working on my >laptop. The only problem I have found with it however is that I haven't >found a suitable ACPI state from which the >system will cleanly recover from. When the machine comes out of S3, I lose >my Speakup review keys. In some cases, there's also a noticable lag, which >is normally replicated during high load >averages or significant disk I/O. I also tried S1, however I couldn't get >the system out of S1 and back to a normalized state. Anyone know how to >get an Inspiron600M out of S1? I attempted >hitting the power button as I did in S3 to wake the system up, however the >machine seemed to be stuck in S1. The only sollution I have found thus far >is to reboot, which defeats the purpose of >ACPI...Anyone have any other ideas/suggestions? Thanks! >- -- >Failure is not an option, it comes bundled with your Microsoft product. >-----BEGIN PGP SIGNATURE----- >Version: GnuPG v1.2.3 (GNU/Linux) > >iD8DBQFA/E+JNohoaf1zXJMRAoiEAJ41MPEvtrIm1QtIZYCBW+GO7V045ACghE8E >PVxgY1HRn9J3aw4cuPxfUmk= >=uF1N >-----END PGP SIGNATURE----- > >_______________________________________________ >Speakup mailing list >Speakup at braille.uwo.ca >http://speech.braille.uwo.ca/mailman/listinfo/speakup Stephen Clower, that guy from the south. You can reach me by any of the following: E-Mail: steve at steve-audio.net MSN: steve at steve-audio.net AIM: AudioRabbit03 You can also check out my little home on the web by visiting http://www.steve-audio.net
