Re: [PATCH 1/2] dt-bindings: serial: rs485: add rs485-mux-gpios binding

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 21/11/2023 08.52, Krzysztof Kozlowski wrote:
> On 20/11/2023 16:10, Rasmus Villemoes wrote:
>> Some boards are capable of both rs232 and rs485, and control which
>> external terminals are active via a gpio-controlled mux. Allow
>> describing that gpio in DT so that the kernel can transparently handle
>> the proper setting when the uart is switched between rs232 and rs485
>> modes.
>>
>> Signed-off-by: Rasmus Villemoes <linux@xxxxxxxxxxxxxxxxxx>
>> ---
>>  Documentation/devicetree/bindings/serial/rs485.yaml | 5 +++++
>>  1 file changed, 5 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
>> index 9418fd66a8e9..e8136c7d22ed 100644
>> --- a/Documentation/devicetree/bindings/serial/rs485.yaml
>> +++ b/Documentation/devicetree/bindings/serial/rs485.yaml
>> @@ -61,6 +61,11 @@ properties:
>>        the active state enables RX during TX.
>>      maxItems: 1
>>  
>> +  rs485-mux-gpios:
>> +    description: GPIO pin to control muxing of the SOC signals to the RS485
>> +      transceiver.
>> +    maxItems: 1
> 
> Aren't you duplicating
> https://lore.kernel.org/all/3Nk.ZZrp.5w3Yn0Ecy5C.1bMzDp@xxxxxxxxx/ ?

Hadn't seen that, but no, this is not at all the same. That patch seems
to define an input pin to tell whether to enable rs485 mode or not (sort
of early run-time version of the linux,rs485-enabled-at-boot-time).

> Anyway, similar comments: this does not look like generic RS485
> property. Are you saying that standard defines such GPIO?

No, I'm saying that several boards that exist in the wild have the
RX/TX/CTS etc. pins routed to a multiplexer, which in turn routes those
signals to either a rs485 transceiver or an rs232 driver (and those in
turn are connected to different screw terminals). So no, it's not a
property of the rs485 protocol itself, but very much related to making
use of rs485 (and rs232, though of course not simultaneously) on such
boards.

Would a link to a schematic help?

Rasmus





[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux