Some boards are capable of both rs232 and rs485, and control which
external terminals are active via a gpio-controlled mux. Allow
describing that gpio in DT so that the kernel can transparently handle
the proper setting when the uart is switched between rs232 and rs485
modes.
Signed-off-by: Rasmus Villemoes <linux@xxxxxxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/serial/rs485.yaml | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
index 9418fd66a8e9..e8136c7d22ed 100644
--- a/Documentation/devicetree/bindings/serial/rs485.yaml
+++ b/Documentation/devicetree/bindings/serial/rs485.yaml
@@ -61,6 +61,11 @@ properties:
the active state enables RX during TX.
maxItems: 1
+ rs485-mux-gpios:
+ description: GPIO pin to control muxing of the SOC signals to the RS485
+ transceiver.
+ maxItems: 1
+
additionalProperties: true
...
--
2.40.1.1.g1c60b9335d
