On Sun, 2018-07-22 at 22:31 +0100, Sudip Mukherjee wrote: > Hi Andy, > > On 16/07/18 15:04, Andy Shevchenko wrote: > > On Mon, 2018-07-16 at 14:59 +0100, Sudip Mukherjee wrote: > > > Hi Andy, > > > > > > On 16/07/18 14:35, Andy Shevchenko wrote: > > <snip> > > > > > > I am traveling this week and will be able to test it on the > > > hardware > > > on > > > the weekend (21st and 22nd). Do you have any specific test to run? > > > > Since it touches configuration parts and PM it would be nice to test > > the > > following: > > - basic stuff that everything work for you as previously (any of > > your > > setup is not broken), or more specific > > - a) the board is detected correctly (number of ports, type, etc) > > - b) the fractional divisor works as expected on affected boards > > (if > > you supply some baud rate on the board which utilizes fractional > > part) > > - c) open, write/read, close, check PM state of the device; repeat > > few > > times; it will ensure that sleep works as before > > I also got the same BUG which Aaron mentioned and I can confirm after > using suggested ioread8() it was working. > Tested with open, read/write, close with the serial port in loopback. > Tested with different baudrates also. > Also suspended the system and confirmed the ports are working after > resume. Thank you very much! It seems Aaron and I need to settle the base on top of which I can re-base this series. I will send new version when above would be done. -- Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> Intel Finland Oy -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
