If the chosen baud rate is large enough (e.g. 3.5 megabaud), the
calculated n values in calculate_baud_abs_diff may become 0. This causes
a division by zero when calculating the difference between calculated
and desired baud rates. To prevent this, cap n on 1.
Signed-off-by: Frans Klaver <frans.klaver@xxxxxxxxx>
---
drivers/tty/serial/omap-serial.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index ae935ce..7d3f557 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -246,8 +246,12 @@ static inline int calculate_baud_abs_diff(struct uart_port *port,
unsigned int baud, unsigned int mode)
{
unsigned int n = port->uartclk / (mode * baud);
- int abs_diff = baud - (port->uartclk / (mode * n));
+ int abs_diff;
+ if (n == 0)
+ n = 1;
+
+ abs_diff = baud - (port->uartclk / (mode * n));
if (abs_diff < 0)
abs_diff = -abs_diff;
--
2.1.0
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
