On Sat, 03 May 2008, Gerhard Mack wrote: > I have an array witjh 6 drives in it and if use the card's utilities on > boot it sees all of them but for some reason Linux only sees 4 drives. > > Am I running into a limit? I can see both drives if I remove other drives > from the array. > > [0:0:0:0] disk MAXTOR ATLAS10K4_36SCA DFM0 /dev/sda > [0:0:1:0] disk MAXTOR ATLAS10K4_36SCA DFM0 /dev/sdb > [0:0:2:0] disk MAXTOR ATLAS10K4_36SCA DFM0 /dev/sdc > [0:0:6:0] process PE/PV 1x3 SCSI BP 0.28 - > fiber channel drives: > [2:0:0:0] disk SEAGATE ST314680 CLAR146 7A0A /dev/sdd > [2:0:1:0] disk SEAGATE ST314680 CLAR146 7A04 /dev/sde > [2:0:2:0] disk SEAGATE ST314680 CLAR146 7A0A /dev/sdf > [2:0:3:0] disk SEAGATE ST314680 CLAR146 7A04 /dev/sdg > > QLogic Fibre Channel HBA Driver > qla2xxx 0000:02:0a.0: Found an ISP2312, irq 24, iobase 0xf88cc000 > qla2xxx 0000:02:0a.0: Configuring PCI space... > qla2xxx 0000:02:0a.0: Configure NVRAM parameters... > qla2xxx 0000:02:0a.0: Verifying loaded RISC code... > qla2xxx 0000:02:0a.0: Allocated (412 KB) for firmware dump... > scsi3 : qla2xxx > qla2xxx 0000:02:0a.0: LIP reset occured (f8f7). > qla2xxx 0000:02:0a.0: LIP occured (f8f7). > qla2xxx 0000:02:0a.0: LOOP UP detected (1 Gbps). Could you load the driver with the ql2xextended_error_logging module parameter set to 1 and send the resultant driver logs? Also, it would could you also send the output of the following after the driver is loaded: $ cat /sys/class/fc_host/host<host_no> $ cat /sys/class/scsi_host/host<host_no>/* $ cat /sys/class/fc_remote_ports/* where host_no corresponds to the SCSI host-number assigned to the HBA. Regards, Andrew Vasquez -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
