Hello, This patch series converts the R-Car DU driver to use the DRM bridge connector helper drm_bridge_connector_init(). The bulk of the v1 series was converting the adv7511, simple-bridge and dw-hdmi drivers to make connector creation optional (through the DRM_BRIDGE_ATTACH_NO_CONNECTOR flag), and have already been merged. v2 included the remaining patches and has bitrotten. v3 rebased the code and should be ready for merge. Patch 1/4 adds support to the dw-hdmi driver to attach to a downstream bridge if one is specified in DT. As the DT port number corresponding to the video output differs between platforms that integrate the dw-hdmi (some of them even don't have a video output port, which should probably be fixed, but that's out of scope for this series), the port number has to be specified by the platform glue layer. Patch 2/4 then addresses the rcar-lvds driver. Instead of implementing direct support for DRM_BRIDGE_ATTACH_NO_CONNECTOR, it simply removes code that shouldn't have been in the driver in the first place by switching to the panel bridge helper. Patch 3/4 specifies the port number in the R-Car dw-hdmi glue layer, as required by 1/4. Patch 4/4 finally makes use of the drm_bridge_connector_init() helper. The series has been tested on the Renesas R-Car Salvator-XS and Draak boards with the VGA, HDMI and LVDS outputs. Laurent Pinchart (4): drm: bridge: dw-hdmi: Attach to next bridge if available drm: rcar-du: lvds: Convert to DRM panel bridge helper drm: rcar-du: dw-hdmi: Set output port number drm: rcar-du: Use drm_bridge_connector_init() helper drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 54 +++++++++- drivers/gpu/drm/rcar-du/rcar_du_encoder.c | 26 ++++- drivers/gpu/drm/rcar-du/rcar_dw_hdmi.c | 1 + drivers/gpu/drm/rcar-du/rcar_lvds.c | 120 +++------------------- include/drm/bridge/dw_hdmi.h | 2 + 5 files changed, 89 insertions(+), 114 deletions(-) -- Regards, Laurent Pinchart
