On Tue, May 29, 2012 at 12:17 PM, Yinghai Lu <yinghai@xxxxxxxxxx> wrote: > On Tue, May 29, 2012 at 10:57 AM, H. Peter Anvin <hpa@xxxxxxxxx> wrote: >> On 05/29/2012 10:55 AM, Yinghai Lu wrote: >>> >>> x86 are using 16bits. >>> >>> some others use 32 bits. >>> #define IO_SPACE_LIMIT 0xffffffff >>> >>> ia64 and sparc are using 64bits. >>> #define IO_SPACE_LIMIT 0xffffffffffffffffUL >>> >>> but pci only support 16bits and 32bits. >>> >>> maybe later we can add >>> PCI_MAX_RESOURCE_16 >>> >>> to handle 16bits and 32bit io ports. >>> >> >> Shouldn't this be dealt by root port apertures? >> > > pci bridge could support 16bits and 32bits io port. > but we did not record if 32bits is supported. > > so during allocating, could have allocated above 64k address to non > 32bit bridge. > > but x86 is ok, because ioport.end always set to 0xffff. > other arches with IO_SPACE_LIMIT with 0xffffffff or > 0xffffffffffffffffUL may have problem. I think current IO_SPACE_LIMIT usage is a little confused. The "ioport_resource.end = IO_SPACE_LIMIT" in kernel/resource.c refers to a CPU-side address, not a bus address. Other uses, e.g., in __pci_read_base(), apply it to bus addresses from BARs, which is wrong. Host bridges apply I/O port offsets just like they apply memory offsets. The ia64 IO_SPACE_LIMIT of 0xffffffffffffffffUL means there's no restriction on CPU-side I/O port addresses, but any given host bridge will translate its I/O port aperture to bus addresses that fit in 32 bits. None of this is really relevant to the question I asked, namely, "why Yinghai's patch doesn't limit I/O BAR values to 32 bits?" That constraint is clearly a requirement because I/O BARs are only 32 bits wide, but I don't think it needs to be enforced in the code here. The host bridge or upstream P2P bridge apertures should already take care of that automatically. I don't think the 16- or 32-bitness of P2P bridge apertures is relevant here, because the I/O resources available on the secondary bus already reflect that. After all that discussion, I think my objection here boils down to "you shouldn't change the I/O BAR constraints in a patch that claims to allocate 64-bit *memory* BARs above 4GB." I think the code below is still the clearest way to set the constraints: if (res->flags & IORESOURCE_MEM_64) { start = (resource_size_t) (1ULL << 32); end = PCI_MAX_RESOURCE; } else { start = 0; end = PCI_MAX_RESOURCE_32; } It's not strictly necessary to limit I/O BARs to PCI_MAX_RESOURCE_32 because host bridge apertures should already enforce that, but I think the code above just makes it clearer. -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html