Re: [PATCH] PCI: tegra: Use PCI_CONF1_EXT_ADDRESS() macro

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Oct 11, 2022 at 05:47:50PM +0100, Jon Hunter wrote:
> 
> On 11/10/2022 17:16, Pali Rohár wrote:
> 
> ...
> 
> > I see, this is stupid mistake. PCIe config read and write operations
> > needs to be 4-byte aligned, so normally it is done by calculating 4-byte
> > aligned base address and then using appropriate cpu load/store
> > instruction to access just defined size/offset of 4-byte config space
> > register.
> > 
> > pci-tegra.c is using common helper functions pci_generic_config_read()
> > and pci_generic_config_write(), which expects final address with offset,
> > and not 4-byte aligned address.
> > 
> > I'm not sure what should be the proper fix, but for me it looks like
> > that pci_generic_config_read() and pci_generic_config_write() could be
> > adjusted to handle it.
> > 
> > In any case, above patch is a regressions and I see there two options
> > for now:
> > 
> > 1) Reverting that patch
> > 
> > 2) Adding "offset |= where & 0x3;" after the PCI_CONF1_EXT_ADDRESS()
> >     macro to set also lower 2 bits of accessed register.
> > 
> > Jon, Lorenzo, what do you think? Could you test if 2) is working fine?
> 
> 
> I tested 'offset |= where & 0xff' which is essentially the same as the above
> and that is working and so I am sure that the above works too. However, I do
> wonder if reverting is simpler because we already have a '&
> ~PCI_CONF1_ENABLE' and now adding '| where & 0x3' seems to diminish the
> value of this change.

Hi Jon,

it is unfortunate but I think we should proceed with a revert, please
send it and I shall ask Bjorn to send it for one of the upcoming -rcX.

Thanks,
Lorenzo



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux