Re: [PATCH] PCI: tegra: Use PCI_CONF1_EXT_ADDRESS() macro

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 11/10/2022 17:16, Pali Rohár wrote:

...

I see, this is stupid mistake. PCIe config read and write operations
needs to be 4-byte aligned, so normally it is done by calculating 4-byte
aligned base address and then using appropriate cpu load/store
instruction to access just defined size/offset of 4-byte config space
register.

pci-tegra.c is using common helper functions pci_generic_config_read()
and pci_generic_config_write(), which expects final address with offset,
and not 4-byte aligned address.

I'm not sure what should be the proper fix, but for me it looks like
that pci_generic_config_read() and pci_generic_config_write() could be
adjusted to handle it.

In any case, above patch is a regressions and I see there two options
for now:

1) Reverting that patch

2) Adding "offset |= where & 0x3;" after the PCI_CONF1_EXT_ADDRESS()
    macro to set also lower 2 bits of accessed register.

Jon, Lorenzo, what do you think? Could you test if 2) is working fine?


I tested 'offset |= where & 0xff' which is essentially the same as the above and that is working and so I am sure that the above works too. However, I do wonder if reverting is simpler because we already have a '& ~PCI_CONF1_ENABLE' and now adding '| where & 0x3' seems to diminish the value of this change.

Cheers
Jon

--
nvpublic



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux