Salut Kevin, On 06/04/2013 12:19 AM, Kevin Hilman wrote: > Florian Vaussard <florian.vaussard@xxxxxxx> writes: > >> Hello Kevin, >> >> On 06/01/2013 12:45 AM, Kevin Hilman wrote: >>> On most OMAP3 platforms, the twl4030 IRQ line is connected to the >>> SYS_NIRQ line on OMAP. Therefore, configure the defaults for the >>> SYS_NIRQ pin in the twl4030 DTS file. >>> >>> Boards that hook up the twl4030 differently can easily override this >>> in their board-specific DTS file. >>> >>> This allows RTC wake from off-mode to work again on OMAP3-based >>> platforms with twl4030. Tested on 3530/Beagle, 3730/Beagle-xM, >>> 3530/Overo, 3730/Overo-STORM. >>> >>> Signed-off-by: Kevin Hilman <khilman@xxxxxxxxxx> >>> --- >>> arch/arm/boot/dts/twl4030.dtsi | 17 +++++++++++++++++ >>> 1 file changed, 17 insertions(+) >>> >>> diff --git a/arch/arm/boot/dts/twl4030.dtsi b/arch/arm/boot/dts/twl4030.dtsi >>> index b3034da..c7fe9f6 100644 >>> --- a/arch/arm/boot/dts/twl4030.dtsi >>> +++ b/arch/arm/boot/dts/twl4030.dtsi >>> @@ -13,6 +13,8 @@ >>> compatible = "ti,twl4030"; >>> interrupt-controller; >>> #interrupt-cells = <1>; >>> + pinctrl-names = "default"; >>> + pinctrl-0 = <&twl4030_pins>; >>> >>> rtc { >>> compatible = "ti,twl4030-rtc"; >>> @@ -92,3 +94,18 @@ >>> #pwm-cells = <2>; >>> }; >>> }; >>> + >>> +&omap3_pmx_core { >> >> Here you are making the TWL4030 to explicitly depend on OMAP3. Could >> this chip be used by another target? If the case, I would put this >> piece of code in the files including twl4030. Otherwise it's ok here. > > I talked this over with Tony before posting. In theorry, it could be > used on other platforms. In practice, it's only used on OMAP. We can > easily move this to board files if needed later, but thought it would be > simpler to put it here. I'll let Benoit decide. Yeah, I don't like that either. Some twl variants are used on other platform. And these variants might include the original twl4030 as a base. None of them are in mainline for sure, but anyway adding SoC stuff in external IC file is not a good practice. I don't want people in the future using that as an excuse for similar hacks. The easiest way is to create an extra file including the platform free twl4030 file and adding the OMAP3 specific config on top of that. Every OMAP3 boards will the used that file. Otherwise you can hack each boards. Regards, Benoit -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html