Hello Grygorii,
On 12/24/2015 06:32 PM, Grygorii Strashko wrote:
On 12/24/2015 05:35 PM, Uri Mashiach wrote:
The power function uses a consumer regulator access to update the WiFi
enable GPIO value.
Signed-off-by: Uri Mashiach <uri.mashiach@xxxxxxxxxxxxxx>
---
v1 -> v2: oops fix was removed to a separate fix.
drivers/net/wireless/ti/wlcore/spi.c | 37
++++++++++++++++++++++++++++++++++++
1 file changed, 37 insertions(+)
diff --git a/drivers/net/wireless/ti/wlcore/spi.c
b/drivers/net/wireless/ti/wlcore/spi.c
[...]
+
static struct wl1271_if_operations spi_ops = {
.read = wl12xx_spi_raw_read,
.write = wl12xx_spi_raw_write,
.reset = wl12xx_spi_reset,
.init = wl12xx_spi_init,
+ .power = wl12xx_spi_set_power,
.set_block_size = NULL,
};
@@ -353,6 +384,12 @@ static int wl1271_probe(struct spi_device *spi)
* comes from the board-peripherals file */
spi->bits_per_word = 32;
+ glue->reg = devm_regulator_get(&spi->dev, "vwlan");
+ if (IS_ERR(glue->reg)) {
It will be more correct to handle -EPROBE_DEFER here also. Like:
if (PTR_ERR(glue->reg) == -EPROBE_DEFER)
return PTR_ERR(glue->reg);
It seems that the IS_ERR(glue->reg) condition covers the EPROBE_DEFER case.
+ dev_err(glue->dev, "can't get regulator\n");
+ return PTR_ERR(glue->reg);
+ }
+
ret = spi_setup(spi);
if (ret < 0) {
dev_err(glue->dev, "spi_setup failed\n");
--
Thanks,
Uri
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
