In the subject: s/Make/Make sure/ On Wed, 17 Oct 2018 16:44:23 +0200 Boris Brezillon <boris.brezillon@xxxxxxxxxxx> wrote: > Some flash_info entries have the SPI_NOR_4B_OPCODES to let the core ^ flag set > know that the flash supports 4B opcode. While this solution works fine > for id-based caps detection, it doesn't work that well when relying on > SFDP-based caps detection. Let's add an SNOR_F_4B_OPCODES flag so that > spi_nor_parse_bfpt() can add it when the BFPT_DWORD1_ADDRESS_BYTES > field is set to BFPT_DWORD1_ADDRESS_BYTES_4_ONLY. > > Reported-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx> > Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx> > --- > drivers/mtd/spi-nor/spi-nor.c | 11 ++++++++--- > include/linux/mtd/spi-nor.h | 1 + > 2 files changed, 9 insertions(+), 3 deletions(-) > > diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c > index 9407ca5f9443..85e57e9ea1b5 100644 > --- a/drivers/mtd/spi-nor/spi-nor.c > +++ b/drivers/mtd/spi-nor/spi-nor.c > @@ -2643,6 +2643,7 @@ static int spi_nor_parse_bfpt(struct spi_nor *nor, > break; > > case BFPT_DWORD1_ADDRESS_BYTES_4_ONLY: > + nor->flags |= SNOR_F_4B_OPCODES; > nor->addr_width = 4; > break; > > @@ -3552,7 +3553,7 @@ static int spi_nor_init(struct spi_nor *nor) > > if ((nor->addr_width == 4) && > (JEDEC_MFR(nor->info) != SNOR_MFR_SPANSION) && > - !(nor->info->flags & SPI_NOR_4B_OPCODES)) { > + !(nor->flags & SNOR_F_4B_OPCODES)) { > /* > * If the RESET# pin isn't hooked up properly, or the system > * otherwise doesn't perform a reset command in the boot > @@ -3586,7 +3587,7 @@ void spi_nor_restore(struct spi_nor *nor) > /* restore the addressing mode */ > if ((nor->addr_width == 4) && > (JEDEC_MFR(nor->info) != SNOR_MFR_SPANSION) && > - !(nor->info->flags & SPI_NOR_4B_OPCODES) && > + !(nor->flags & SNOR_F_4B_OPCODES) && > (nor->flags & SNOR_F_BROKEN_RESET)) > set_4byte(nor, nor->info, 0); > } > @@ -3744,11 +3745,15 @@ int spi_nor_scan(struct spi_nor *nor, const char *name, > nor->addr_width = 4; > if (JEDEC_MFR(info) == SNOR_MFR_SPANSION || > info->flags & SPI_NOR_4B_OPCODES) > - spi_nor_set_4byte_opcodes(nor, info); > + nor->flags |= SNOR_F_4B_OPCODES; > } else { > nor->addr_width = 3; > } > > + if (info->addr_width == 4 && We should check nor->addr_width not info->addr_width. > + nor->flags & SNOR_F_4B_OPCODES) > + spi_nor_set_4byte_opcodes(nor, info); > + > if (nor->addr_width > SPI_NOR_MAX_ADDR_WIDTH) { > dev_err(dev, "address width is too large: %u\n", > nor->addr_width); > diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h > index 7f0c7303575e..4ffb165f4f85 100644 > --- a/include/linux/mtd/spi-nor.h > +++ b/include/linux/mtd/spi-nor.h > @@ -236,6 +236,7 @@ enum spi_nor_option_flags { > SNOR_F_READY_XSR_RDY = BIT(4), > SNOR_F_USE_CLSR = BIT(5), > SNOR_F_BROKEN_RESET = BIT(6), > + SNOR_F_4B_OPCODES = BIT(7) Missing comma at the end of the line. I'll send a v2 soon. ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/