Some flash_info entries have the SPI_NOR_4B_OPCODES flag set to let the core know that the flash supports 4B opcode. While this solution works fine for id-based caps detection, it doesn't work that well when relying on SFDP-based caps detection. Let's add an SNOR_F_4B_OPCODES flag so that spi_nor_parse_bfpt() can add it when the BFPT_DWORD1_ADDRESS_BYTES field is set to BFPT_DWORD1_ADDRESS_BYTES_4_ONLY. Reported-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx> Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx> --- Changes in v2: - Fix the commit message - Fix the ->addr_width check - Add a comma at the end of the SNOR_F_4B_OPCODES definition --- drivers/mtd/spi-nor/spi-nor.c | 11 ++++++++--- include/linux/mtd/spi-nor.h | 1 + 2 files changed, 9 insertions(+), 3 deletions(-) diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c index 9407ca5f9443..9155d3b9c37b 100644 --- a/drivers/mtd/spi-nor/spi-nor.c +++ b/drivers/mtd/spi-nor/spi-nor.c @@ -2643,6 +2643,7 @@ static int spi_nor_parse_bfpt(struct spi_nor *nor, break; case BFPT_DWORD1_ADDRESS_BYTES_4_ONLY: + nor->flags |= SNOR_F_4B_OPCODES; nor->addr_width = 4; break; @@ -3552,7 +3553,7 @@ static int spi_nor_init(struct spi_nor *nor) if ((nor->addr_width == 4) && (JEDEC_MFR(nor->info) != SNOR_MFR_SPANSION) && - !(nor->info->flags & SPI_NOR_4B_OPCODES)) { + !(nor->flags & SNOR_F_4B_OPCODES)) { /* * If the RESET# pin isn't hooked up properly, or the system * otherwise doesn't perform a reset command in the boot @@ -3586,7 +3587,7 @@ void spi_nor_restore(struct spi_nor *nor) /* restore the addressing mode */ if ((nor->addr_width == 4) && (JEDEC_MFR(nor->info) != SNOR_MFR_SPANSION) && - !(nor->info->flags & SPI_NOR_4B_OPCODES) && + !(nor->flags & SNOR_F_4B_OPCODES) && (nor->flags & SNOR_F_BROKEN_RESET)) set_4byte(nor, nor->info, 0); } @@ -3744,11 +3745,15 @@ int spi_nor_scan(struct spi_nor *nor, const char *name, nor->addr_width = 4; if (JEDEC_MFR(info) == SNOR_MFR_SPANSION || info->flags & SPI_NOR_4B_OPCODES) - spi_nor_set_4byte_opcodes(nor, info); + nor->flags |= SNOR_F_4B_OPCODES; } else { nor->addr_width = 3; } + if (nor->addr_width == 4 && + nor->flags & SNOR_F_4B_OPCODES) + spi_nor_set_4byte_opcodes(nor, info); + if (nor->addr_width > SPI_NOR_MAX_ADDR_WIDTH) { dev_err(dev, "address width is too large: %u\n", nor->addr_width); diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h index 7f0c7303575e..5bc75110d5ea 100644 --- a/include/linux/mtd/spi-nor.h +++ b/include/linux/mtd/spi-nor.h @@ -236,6 +236,7 @@ enum spi_nor_option_flags { SNOR_F_READY_XSR_RDY = BIT(4), SNOR_F_USE_CLSR = BIT(5), SNOR_F_BROKEN_RESET = BIT(6), + SNOR_F_4B_OPCODES = BIT(7), }; /** -- 2.14.1 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/